Abstract:Wireless Power Transfer (WPT) brings convenience and safety in many applications and serves as a research hot spot in recently years. Magnetic resonant coupling is widely implemented in WPT applications such as mobile devices and electric vehicles where large distance, large power amount and high efficiency are the three key requirements in real application. However, there are always trade-offs between these requirements even in theory. Former literatures failed to illustrate the complete relationships between these requirements. Based on the phasor analysis, this paper illustrates the operating principle of the whole circuit, attains the equivalent circuit models of the system and derives the physical essence of frequency characteristics. Then Maximum Efficiency Conditions (MEC), which achieves the maximum efficiency without sacrificing the requirements for power transfer distance and power amount, is summarized. It should be noted that the highest efficiency is achieved at the natural frequency of the receiver, instead of any split frequencies of the coupled resonances. Following the MEC, a WPT prototype was designed, which was composed of a full bridge inverter, a LC resonant transmitter, a LC resonant receiver and a full bridge rectifier. The resonant frequency of the transmitter was designed to be slightly lower than the inverter operation frequency-446kHz to make an inductive load for the inverter so that all the MOSFETs operated in Zero-Voltage-Switching (ZVS) condition. For the experimental results, 300 W output power was obtained over a distance of 22cm with 84% overall efficiency.

Optimized Resonant Network Design for High Energy Transfer Efficiency of the WPT System

Optimal parameters design for series-series resonant converter for wireless power transfer

A Reconfigurable Resonant Topology of Wireless Power Transfer Systems with Large Coupling Ranges

A Method of Resonant Frequency Optimized Selection for a SP Inductive Coupled Power Transfer System

Design and Optimization of a Modular Wireless Power System Based on Multiple Transmitters and Multiple Receivers Architecture

An Optimization Method for Compensation Network Parameters in Double-Sided LCC Wireless Power Transfer System

Detuned Resonant Capacitors Selection for Improved Misalignment Tolerance of LCC-S Compensated Wireless Power Transfer System

Design of an LCC-SP Compensated WPT System and Parameters Tuning Method for Misalignment Condition

Reconfigurable Resonant Topology Linking Two-, Three-, and Four-Coil Modes for WPT with Large Coupling Range and Fixed Frequency

Research on Transfer Mechanism and Power Improvement Technology of the SCC-WPT System

Parameters Optimized Design of Electrolytic-Capacitor-Less LCC-S WPT System to Improve Efficiency

Study of a Magnetic Coupling Resonant Wireless Power Transfer System

An Efficiency Optimization Method for the Multiple Coils WPT System Against the Pad Misalignment

Efficiency‐based Design Optimisation of a Double‐sided LCL Compensated Wireless Power Transfer System

Optimized Design of Passive Array Coils for HighEfficiency and Anti-Misalignment WPT System

Self-adaptive Resonance Technology for Wireless Power Transfer Systems to Eliminate Impedance Mismatches

Dual-Phase-Shift Control Strategy With Switch-Controlled Capacitor for Overall Efficiency Optimization in Wireless Power Transfer System

An Integrated Double-Sided LCC Compensation Based Dual-Frequency Compatible WPT System with Constant-Current Output and ZVS Operation

A simplified model and its parameters optimization methodology of LCC‐S WPT compensation network under dual‐side‐detuned conditions

Study on Efficiency Maximization Design Principles for Wireless Power Transfer System Using Magnetic Resonant Coupling

A Misalignment Tolerant Design for a Dual-Coupled LCC-S-Compensated WPT System With Load-Independent CC Output