Abstract:Residual stresses can have detrimental effect on the life cycle of engineering components and can affect the accuracy of the fatigue life prediction models. Accurate measurement of these stresses are therefore crucial. . However, destructive and semi-destructive methods of measuring residual stresses often cause damage to the components. In contrast, the non-destructive ultrasonic method allows for intact measurement of residual stresses even, in situation where portability is not feasible. Various waves can be utilized in the ultrasonic method for measuring residual stresses. In this study, longitudinal critically refracted (LCR) waves were employed due to their higher sensitivity, larger scanning area, and lower sensitivity to texture effect, making them preferable over other waves. The purpose of this study was to investigate the influence of plasticity on the measurement of residual stresses using the ultrasonic method. To achieve this, two stainless steel disks were subjected to quenching at temperatures of 300 °C and 700 °C to induce different levels of residual stresses and plasticity. The material properties of the disks were determined through standard tensile tests to facilitate numerical simulations. Tensile test specimens were extracted from the initial sheet to measure the yield stress and modulus of elasticity. The coefficient of acoustoelasticity, was determined by subjecting the tensile test specimens to different stress levels and recording the wave flight time. The coefficient of acoustoelasticity for stainless steel 316Lwas obtained using the slope of and (E(t-t0))/t0,. Residual stresses were experimentally measured using both the ultrasonic method and the center-hole drilling method, and the results were compared with those obtained from numerical analyses. The findings from center-hole drilling method, ultrasonic method, and numerical simulation were then compared and discussed. Different levels of plasticity were considered, and the accuracy of measuring residual stresses was analyzed and evaluated.

Ultrasonic evaluation of residual stresses in aero engine materials using bulk and Rayleigh surface waves

Depth-sensing Indentation Measurement and Finite Element Analysis of Residual Stress Field Near Fatigue Crack Tip

Acoustoelastic determination of local surface stresses in polymethylmethacrylate

Research of Ultrasonic Inspection for Complex Form Aircraft Forging Component

Non-destructive evaluation of non-uniform stress fields and subsurface stress gradients using ultrasonic waves

Nondestructive Evaluation of Residual Stress in Shot Peened Inconel Using Ultrasonic Minimum Reflection Measurement

Depth profiling of residual stress distribution in surface treated metallic structures using nonlinear ultrasonics

Non-contact Measurements of Residual Stress Distribution and Grain Size in Titanium Alloys with Laser Ultrasonic System

Comparative investigation of ultrasonic cavitation erosion for two engineering materials

A study on the effect of plasticity on the measurement of residual stresses using ultrasound technique

Ultrasonic and structural characterization of anisotropic austenitic stainless steel welds: Towards a higher reliability in ultrasonic non-destructive testing

Effect of Anisotropy on Residual Stress Measurement of 316L Stainless Steel by Ultrasonic Surface Wave

Ultrasonic nondestructive characterization and its role in the development and implementation of additive manufacturing processes

Study of Residual Stress Using Phased Array Ultrasonics in Ti-6AL-4V Wire-Arc Additively Manufactured Components

Mechanical and Microstructural Assessment of Inhomogeneities in Oxide Ceramic Matrix Composites Detected by Air-Coupled Ultrasound Inspection

Ultrasonics methodology for defect and stress detection of in-serviced T-shaped R-zone components

Finite element simulation and experimental verification of ultrasonic non-destructive inspection of defects in additively manufactured materials

Ultrasonic and FEM residual stress measurement in dissimilar St37–St52 welding

Process qualification, additive manufacturing, and postprocessing of a hydrogen peroxide/kerosene 6 kN aerospike breadboard engine

Effects of factors from practical workpieces on ultrasonic LCR method stress measurement

Ultrasonic stress detection and regulation in the whole machining process of thin-walled part