Abstract:Surface microtexturing has been widely used due to its good hydrophobic or drag reduction characteristics, and become an effective method to improve product performance and reduce energy consumption. This paper mainly discusses the improvement of microtextures on the dynamic pressure characteristics of hydrostatic bearings, and explores the effects of texture parameters on carrying capacity, macroscopic wall two-plane shear force, cavity area and other factors. In the oil film model calculation of the smooth wall surface of the radial hydrostatic bearing under the action of high speed and large external load, the oil film divergent wedge often has a negative pressure area, which is obviously not in line with the actual situation, so the cavitation effect needs to be considered. The CFD analysis method of the "gas-oil" two-phase flow model was carried out by using the mixture model to seek the optimal texture model scheme and thus to improve the load carrying capacity (LCC) and reduce the wall shear force. The effects of the texture area arrangement and geometric parameters on the lubrication characteristics were compared and analyzed. It is found that the carrying capacity of local texture is better than that of global texture, and different texture arrangements can achieve better drag reduction rates. The work presented in this paper studies the lubrication of the surface texture of a hydrostatic bearing. Taking the oil film carrying capacity and shear force as the target parameters, the factors, such as texture morphology, geometric parameters, texture distribution and cavitation phenomenon, are investigated through simulation and experimental methods. The surface textured hydrostatic bearing is expected to obtain the maximum oil film carrying capacity and the minimum friction resistance. The analysis results show that by arranging the partial streamwise texture at the rear end of the diverging wedge, the maximum shear force of the wall can be reduced by about 15%, and the LCC can be increased by about 18%.

Influence of Geometric Shapes on the Hydrodynamic Lubrication of a Partially Textured Slider With Micro-Grooves

Geometric Shape Effects of Surface Texture on the Generation of Hydrodynamic Pressure Between Conformal Contacting Surfaces

Investigations of the Micro Surface Shape for the Gear-Shaft/journal-bearing Interface in Water Hydraulic Internal Gear Pumps

Effect of Micro-Dimples on Hydrodynamic Lubrication of Textured Sinusoidal Roughness Surfaces

Numerical simulation of hydrodynamic lubrication performance for continuous groove-textured surface

An Analytical And Experimental Parametric Study of Texturing In Slider Bearings Under Hydrodynamic/Mixed Lubrication

Numerical Investigation of the Tribological Performance of Micro-Dimple Textured Surfaces under Hydrodynamic Lubrication

Numerical Analyses of Rectangular Micro-Textures in Hydrodynamic Lubrication Regime for Sliding Contacts

Theoretical Analysis on Hydrodynamic Lubrication of Cylinder Micro-dimple Surface Texture

Influence of Micro Trapezoidal-Groove on Behavior of Sliding Tribopairs

Numerical Simulation of Lubrication Performance on Chevron Textured Surface under Hydrodynamic Lubrication

Hydrodynamic Lubrication of Textured Infinitely Long Slider with Cross-Hatched Texture

Numerical Simulation and Experimental Investigation on Tribological Performance of Micro-Dimples Textured Surface under Hydrodynamic Lubrication

Lubricity Comparison of Various Micro-grooves on a Flat Surface of Sliding Tribo-pairs

Numerical analysis of lubrication properties on a bio-inspired parabolic textured surface

Influence of Cross-Grooved Texture Shape on Tribological Performance under Mixed Lubrication

Effect of Surface Texture Distribution Parameters on Hydrodynamic Lubrication and Numerical Optimization

2D CFD Analysis of Micro Arc-Groove on the Surface of Tribopairs

Optimization of Groove Texture Profile to Improve Hydrodynamic Lubrication Performance: Theory and Experiments

Hydrodynamic lubrication of microdimple textured surface using three-dimensional CFD

Drag Reduction Analysis of the Hydrostatic Bearing with Surface Micro Textures