Abstract:Power electronic modules are used in engineering related to the need to transmit high-current signals. Typical areas of application of such modules are aircraft navigation systems, elements of switching power circuits and other high-load connections. The central unit of the module is a ceramic base, on which conductive tracks are formed and electronic components are mounted. The finished substrate is often called a switchboard. The substrate performs two main functions: Is the dielectric basis of the printed circuit formed on one or two sides. Provides heat dissipation emitted by semiconductor crystals and circuit elements. Used for substrates non-hygroscopic ceramics, heat-resistant, is an insulating material with high mechanical and dielectric properties. It is relatively easy to manufacture and low cost. In the manufacture of power modules using ceramic substrates of aluminum oxide or nitride with a multilayer metallized coating with a thickness of several microns to several tens of microns (depending on the application), which provides the required degree of adhesion of the coating to ceramics and applied on one or both sides. The main requirements for the finished product are the minimum dimensions and low cost of materials and production process. In addition, the decisive factors are high technical characteristics, resistance to environmental influences and reliability. The design of the finished module must provide minimum values of transient thermal resistances, distributed inductances of power busbars, high insulation voltage. Adhesion strength depends on many factors: coating technology, film material, substrate material; and may decrease during operation of the finished product. During the operation of power modules, they are subjected to thermal and mechanical loads, including vibration. This leads to the destruction of components from overheating and damage to the mechanical damage of the modules. Often the failure occurs in the structure of the substrate-coating conductor. The main reason for this destruction is the low adhesive strength of the metal film to the ceramic base.

Processing of metallization technology aluminum oxide ceramics for electro-vacuum devices elements and power electronics devices

Progress of Research on the Alumina Ceramics Metallization

METHODS OF METALIZATION OF CERAMICS USED IN PRODUCTION OF POWER ELECTRONIC MODULES AND ELECTRIC VACUUM DEVICES

S0430204 Formation and Its Process Analysis of Metal Films by Mechanical Coating Technique

Electro-thermal control of aluminum-doped zinc oxide/vanadium dioxide multilayered thin films for smart-device applications

Aerosol Deposition for Ceramic Thick Film Formation at Room Temperature

Behaviors of Micro-Arcs, Bubbles, and Coating Growth during Plasma Electrolytic Oxidation of β-Titanium Alloy

Thermal Stability And Electrical Properties Of Titanium-Aluminum Oxide Ultrathin Films As High-K Gate Dielectric Materials

Advancements in Metal Oxide Thin Film Quality in Solution-Processed High-κ Dielectrics for High-Performance Transistors

Processing of Ti-24 Al-14 Nb-3 V alloy foils

Laser-induced surface activation of LTCC materials for chemical metallization

Morphology And Wear Resistance Of Composite Coatings Formed On A Ta2 Substrate Using Hot-Dip Aluminising And Micro-Arc Oxidation Technologies

Atomic Layer Deposition of Metal Oxide Films

High-Performance Low-Voltage Thin-Film Transistors: Experimental and Simulation Validation of Atmospheric Pressure Plasma-Assisted Li5AlO4 Metal Oxide Solution Processing

Development of A Directly Bonded Aluminum/Alumina Power Electronic Substrate

Fabrication Of Multilayers Coatings Of Intermetallic Compound On Micro-Crystallization Ti-6al-4v Sheet By Al-Foil Pack Aluminizing

Progress in Research of Film Technology for Titanium Alloys

High-efficiency Metal-insulator-Metal Electron Emitter based on Porous Alumina Film

Coatings-electrodes for processing dielectric aluminum oxide ceramics on a wire electrical discharge machine

Effect of plasma-electrolytic oxidation on mechanical properties of titanium coatings

Effects of K2TiF6 and Electrolyte Temperatures on Energy Consumption and Properties of MAO Coatings on 6063 Aluminum Alloy