Abstract:<p>In order to be able to predict train interior noise, it is first important to calculate the external sound pressure distribution on the floor, sidewalls and roof. This can then be combined with the transmission loss of the train panels to determine the interior noise. Traditional techniques such as the finite element and boundary element (FE/BE) methods in three dimensions (3D) can achieve this result but are computationally very expensive. In this paper, a wavenumber-domain boundary element (2.5D BE) approach is instead adopted to predict the propagation of rolling noise from the wheels, rails and sleepers to the train external surfaces. In the 2.5D models, only the cross-section of the vehicle is represented by using boundary elements, while the third direction is considered in terms of a spectrum of wavenumbers. The rail is treated directly in the wavenumber domain but, to include the wheel, a method of representing point sources in a 2.5D approach is developed. An inverse Fourier transform is applied to obtain the spatial distribution of the sound pressure on the train surfaces. The validity of this approach has been verified by comparison with experimental data. The 2.5D BE method was first used to predict the sound distribution on a 1:5 scale train surfaces due to a point source below the vehicle, and later it was used to predict the sound pressure on a full-scale metro vehicle due to a loudspeaker. Comparisons of predictions with measurements on the scale model and on the metro vehicle showed good agreements. For a point source below the vehicle, the sound pressure levels on the train floor were found to be around 20 dB higher than on the sides, and the sound pressure on the train roof was negligible. The 2.5D BE method was also used to predict the sound pressure on the metro vehicle surfaces in running operation, in which the predicted sound pressure levels on the train external surfaces agreed with measurements to within 3 dB and similar trends were found in terms of spectra and longitudinal distribution of pressure.</p>

Sound field study of a building near a roadway via the boundary element method

Simulation and Experimental Demonstration of Sound Field Control Using Beam Deflection

Analysis on Low-Frequency Noise Induced by Vehicle-Bridge Coupling Vibration

Assessment on Transient Sound Radiation of a Vibrating Steel Bridge Due to Traffic Loading

Analysis of Wind Vibration Characteristics of a Narrow-shaped Steel Residential High-rise Building

Assessment of Sound Pressure of Transient Noise Radiated from Vehicle-Bridge Coupling Vibration

Theoretical analysis of low-frequency noise radiated from bridge vibrations

The Calculating Model of Sound Field Distribution along the Urban Elevated Railway

Simulation and Analysis of Road Traffic Noise among Urban Buildings Using Spatial Subdivision-Based Beam Tracing Method

Prediction of Noise Reduction Effect of Sound Barriers and Evaluation of Noise Annoyance

Simulation Model of Sound Field in Street Space Caused by Noise Transmitted from Bordering Large Workshop Buildings

Using a 2.5D boundary element model to predict the sound distribution on train external surfaces due to rolling noise

Traffic noise distribution characteristics of high-rise buildings along ultra-wide cross section highway with multiple noise reduction measures

Estimating the acoustical properties of locally reactive finite materials using the boundary element method

Theoretical and numerical analysis on low-frequency sound transmission from façades into room

A 2.5D acoustic finite element method applied to railway acoustics

Effect of large bus body reflection on sound barrier efficiency for road traffic noise control: a simulation study

Running Cars Induced Wind Loads on Sound Barrier of Elevated Roads

Numerical modeling and field test of sonic crystal acoustic barriers

A coherent model of sound propagation in long enclosures with different acoustics boundaries

Efficient calculation of the three-dimensional sound pressure field around a slab track