Abstract:An electromechanically-coupled micro-contact resistance measurement system is built to mimic the contact process during fatigue testing of nanoscale-thickness interconnects using multiple probe methods. The design combines an optical microscope, high-resolution electronic balance, and micromanipulator-controlled electric probe, and is coupled with electrical measurements to investigate microscale contact physics. Experimental measurements are performed to characterize the contact resistance response of the gold nanocrystalline pad of a 35-nm-thick interconnect under mechanical force applied by a tungsten electrode probe. Location of a stable region for the contact resistance and the critical contact force provides better understanding of micro-contact behavior relative to the effects of the contact force and the nature of the contact surface. Increasing contact temperature leads to reduced contact resistance, softens the pad material, and modifies the contact surface. The stability of both contact resistance and interconnect resistance is studied under increasing contact force. Major fluctuations emerge when the contact force is less than the critical contact force, which shows that temporal contact resistance will affect interconnect resistance measurement accuracy, even when using the four-wire method. This performance is demonstrated experimentally by heating the Au line locally with a laser beam. Finally, the contact resistances are calculated using the LET (Li–Etsion–Talke) model together with combined Holm and Sharvin theory under various contact forces. Good agreement between the results is obtained. This research provides a way to measure change in interconnect line resistance directly under a stable contact resistance regime with a two-wire method that will greatly reduce the experimental costs.

Probing material conductivity in two-terminal devices by resistance difference

Fabrication of a microscopic four-point probe and its application to local conductivity measurement

Development of a New Microscopic Four-Point AFM Probe for the Measurement of Local Electrical Conductivity

NOVEL AFM PROBE FOR LOCAL CONDUCTIVITY MEASUREMENT

A three-probe method for accurate nanoscale thermal transport measurements

A Modified Four-Probe Method to Separate Ionic Conductance from Composite Conductors

Study on the Resistance Distribution at the Contact Between Molybdenum Disulfide and Metals.

Methodology for Measurement of Submicron Metallic Wire's Local Electrical Conductivity by Applying Four-points AFM Probe Technique

A Methodology for Quantitative Evaluation of Local Electrical Conductivity: from Micron to Submicron

Quantification of the sheet resistance between two-dimensional semiconductors and semi-metals by a contact-end-resistance method

Resistance profile measurements on a symmetric electrical pulse induced resistance change device

Identification of the conductivity type of single-walled carbon nanotubes via dual-modulation dielectric force microscopy

Measurement of junction conductance and proximity effect at superconductor/semiconductor junctions

Probing TES Transitions by Lead-Position- Dependent Resistance Measurement

A Two-Sensor 3Ω-2Ω Method for Thermal Boundary Resistance Measurement

Sensitivity Analysis Of Sensor Probe For Low Thermal Diffusivity Properties Measurement

Probing Electrical Transport in Nanomaterials: Conductivity of Individual Carbon Nanotubes

Contactless Measurement of Sheet Resistance of Nanomaterial Using Waveguide Reflection Method

A Scanning Probe Microscopy Based Assay for Single-Walled Carbon Nanotube Metallicity

Measuring Electrical Resistivity at the Nanoscale in Phase-Change Materials

Characterization of Micro-Contact Resistance Between A Gold Nanocrystalline Line and A Tungsten Electrode Probe in Interconnect Fatigue Testing