Abstract:Determination of the distribution of a generated acoustic field is valuable for studying ultrasonic transducers, including providing the guidance for transducer design and the basis for analyzing their performance, etc. A method calculating the acoustic field based on laser-measured vibration velocities on the ultrasonic transducer surface is proposed in this paper. Without knowing the inner structure of the transducer, the acoustic field outside it can be calculated by solving the governing partial differential equation (PDE) of the field based on the specified boundary conditions (BCs). In our study, the BC on the transducer surface, i.e. the distribution of the vibration velocity on the surface, is accurately determined by laser scanning measurement of discrete points and follows a data fitting computation. In addition, to ensure the calculation accuracy for the whole field even in an inhomogeneous medium, a finite element method is used to solve the governing PDE based on the mixed BCs, including the discretely measured velocity data and other specified BCs. The method is firstly validated on numerical piezoelectric transducer models. The acoustic pressure distributions generated by a transducer operating in an homogeneous and inhomogeneous medium, respectively, are both calculated by the proposed method and compared with the results from other existing methods. Then, the method is further experimentally validated with two actual ultrasonic transducers used for flow measurement in our lab. The amplitude change of the output voltage signal from the receiver transducer due to changing the relative position of the two transducers is calculated by the proposed method and compared with the experimental data. This method can also provide the basis for complex multi-physical coupling computations where the effect of the acoustic field should be taken into account.

Characterization of the acoustic field generated by a horn shaped ultrasonic transducer

Modeling Characterization and Optimization Design for PZT Transducer Used in Near Field Acoustic Levitation

Building the Isotropic Acoustic Potential Well with Strong Constraint Boundary to Improve the Stability of Ultrasonic Transportation

Calculation of Acoustic Field Based on Laser-Measured Vibration Velocities on Ultrasonic Transducer Surface

Design and Characterization of Ultrasonic Langevin Transducer 20 kHz Using a Stepped Horn Front-Mass

Finite-element and Experimental Study of Ultrasonic Beam Pattern Characterization

Acoustic Characterization of High Intensity Focused Ultrasound Field Generated from a Transmitter with Large Aperture

Acoustic Characterization Of High Intensity Focused Ultrasound Fields Generated From A Transmitter With A Large Aperture

Study of acoustic tweezer for a middle hollow piston transducer

Design of Ultrasonic Transducer with a Quarter Wavelength Composite Exponential Horn

Enhanced standing-wave acoustic levitation using high-order transverse modes in phased array ultrasonic cavities

Acoustic Field Characterization of Medical Array Transducers Based on Unfocused Transmits and Single-Plane Hydrophone Measurements

Theoretical and Experimental Study of the Nonlinear Ultrasonic Field Radiated from A Conical Focused Pvdf Transducer

Design and Analysis of Ultrasonic Composite Transducer with a Quarter-wave Taper Transition Horn

Design of an electromechanical system for measuring and monitoring micro-ultrasonic amplitude of Langevin transducer

An approach to designing the ultrasonic transducer emission array

Deep-Level Stereoscopic Multiple Traps of Acoustic Vortices

Ultrasound field measurement using a binary lens

Design Optimization and Experimental Study of Acoustic Transducer in Near Field Acoustic Levitation.

Acoustic Field of an Ultrasonic Cavity Resonator with Two Open Ends: Experimental Measurements and Lattice Boltzmann Method Modeling

Study on multi-frequency characteristics of a longitudinal ultrasonic transducer with stepped horn