Abstract:A novel series of linear, high molecular weight aromatic copolymers containing trifluoromethyl and dimethylamino groups was synthesized via facile super-acid catalyzed polyhydroxyalkylation and investigated as CO 2 gas separation membrane materials. The molar ratio of the two ketone comonomers used in copolymerization, trifluoroacetophenone (TFAp) and N,N-dimethylamino trifluoroacetophenone (dMATFAp), was systematically varied to produce five copolymers with different dMATFAp contents ranging from 12 to 73 %. The influence of dMATFAp content on physicochemical and mechanical properties as well as pure gas and water vapor separation performance was studied. All synthesized copolymers displayed excellent film forming ability, high thermal stability and high T g values (T gs > 380 °C). Pure gas permeability measurements revealed that the increase of dMATFAp molar content from 12 % to 34 % resulted in improved gas permeability, while, on the contrary, further increase of dMATFAp content from 34 to 73 % led to substantial gas permeability decrease ascribed to FFV decrease. In particular, among copolymers, the one with dMATFAp content of 34 % presented the highest CO 2 permeability value of 290 Barrer due to its highest CO 2 diffusion and CO 2 solubility coefficients associated with its higher FFV value. The CO 2 /CH 4 performance of synthesized copolymers fell very close to 2008 upper bound limit and exceeded most of the super-acid catalyzed copolymer membranes reported in the literature and commercial membranes. CO 2 /CH 4 and CO 2 /N 2 selectivity values for the different synthesized copolymers were in the range of 29.9–40 and 22.7–44, respectively. The study of the effect of dMΑTFA on water permeability unveiled that the membrane with the highest dMΑTFAp molar content (73 %) showed the highest water permeability value (23,100 Barrer) as well. This was attributed to the increased concentration of N-methyl substituent of dMΑTFAp which can interact with water molecules thereby increasing solubility. Under process gas stream conditions using a mixture of 3 % H 2 O-48.5 % CO 2 -48.5 % CH 4 , both CH 4 and CO 2 permeability were significantly reduced (by 35 % and 47 %, respectively) due to the preferential sorption of water vapor over other gases present in the mixture, highlighting the negative effect of water vapor on gas permeability. Accordingly, the CO 2 /CH 4 separation factor was slightly increased from 23.8 to 29. Finally, stability test of the copolymer (BP-TFAp) 66 -(BP-dMATFAp) 34 at 40 °C under humid mixed gas conditions showed that CO 2 and CH 4 permeability remained unchanged for one month after an initial condition stabilization that is required implying that these copolymer structures are promising materials for CO 2 separation.

Influence of swelling in supercritical carbon dioxide of Ultem and polyhexafluoropropylene thin films on their gas separation properties: comparative analysis

Diffusion and Swelling of Carbon Dioxide in Amorphous Poly(ether Ether Ketone)s

High molecular weight graft stabilisers for dispersion polymerisation of vinylidene fluoride in supercritical carbon dioxide: the effect of architecture

Influence of Swelling in a Solvent Vapor on the Dielectric Properties of Polystyrene and Polyvinylpyridines Films

Structural Investigation And Barrier Properties Of A-C : H Thin Films On Polymer By Pecvd

High-Pressure CO2 Sorption in Polymers of Intrinsic Microporosity under Ultrathin Film Confinement

In-situ visual measurement of poly(methyl methacrylate) swelling in supercritical carbon dioxide and interrelated thermodynamic modeling

Experimental Study for the Sorption and Diffusion of Supercritical Carbon Dioxide into Polyetherimide

Preparation and characterization of highly heat-resistant, soluble, and hydrophobic fluorinated polyimides with gas transport properties

Hydrophobic Properties of Thin Films of Comb-Shaped Perfluorohexylethyl Methacrylate-Polydimethylsiloxane Copolymers Deposited from Supercritical Carbon Dioxide Solutions

STRUCTURE AND PROPERTIES OF POLYETHYLENE TEREPHTHALATE TREATED BY SUPERCRITICAL CO2

Swelling of rubbers of different chemical natures in supercritical carbon dioxide

Synthesis of fluorinated ether free aromatic backbone copolymers containing trifluoromethyl and dimethylamino groups for CO 2 separation: Investigation of pure and mixed gas performance under dry and humid conditions

Insulating Property Improvement Of Polyimide In Devices By Low-Temperature Supercritical Fluids

Experimental Research on Swelling and Glass Transition Behavior of Poly(methyl Methacrylate) in Supercritical Carbon Dioxide

Estimation of the Effects of CO2 and Temperature on the Swelling of PS-CO2 Mixtures at Supercritical Conditions on Rheological Testing

Batch foaming of ultra-high molecular weight polyethylene with supercritical carbon dioxide: Influence of temperature and pressure

Finely tuning the microporosity in dual thermally crosslinked polyimide membranes for plasticization resistance gas separations

Suppression of Crystallization in Thin Films of Cellulose Diacetate and Its Effect on CO2/CH4 Separation Properties

Nano-Confinement Effects on Structural Development and Organic Solvent-Induced Swelling of Ultrathin Carbon Molecular Sieve Films

Dissolution of Polymer Films in Supercritical Carbon Dioxide Using A Quartz Crystal Microbalance