Abstract:The central diaphragm is often used to reduce the span to maintain the stability and safety of structure in the construction of large-span loess tunnel due to the structure complexities. In this paper, relying on the field monitoring and measurement for Wangcun tunnel in Huangling-Yan’an expressway expansion project, the crown settlement and horizontal convergence of primary support steel rib and central diaphragm steel rib during the construction are analyzed by the upper bench CD method. According to the internal force transfer, deformation coordination, and arch foot displacement between the two structures, the support system is regarded as the arch-beam fixed structure with three times of statically indeterminate and movable abutment under the loads, and the mechanical calculation model of sidewall steel rib and the central diaphragm structure bearing loads and deformation together is established. Finally, through the mechanical model mentioned above, the deformation characteristics of central diaphragm structure and the horizontal convergence in the upper bench of tunnel are calculated and analyzed. The research shows the following: (1) the accumulated settlement of sidewall steel rib in Part I is greater than that of the sidewall steel rib in Part II, and the accumulated settlement of each part at the support structure during the tunnel excavation is less than the reserved deformation of 150 mm specified in the tunnel excavation; (2) the settlement located at the waist and maximum excavation line position of central diaphragm is mainly affected by the excavation of Parts I and II in upper bench; (3) during the whole excavation process, the excavation of Part I and Part II has the greatest influence on the convergence at arch waist and the maximum excavation line position in Part I, and the convergence at the above two positions all experienced four stages of “convergence-expansion-convergence-gradual stability”; and (4) the errors between the horizontal convergence and the deformation of central diaphragm obtained by the mechanical model and the field monitoring data are between 12.7% and 27.5%. The calculated results are in good agreement with the actual situation. The research can provide a theoretical basis for the study of deformation and mechanical properties for support structure in the construction of large-span loess tunnel by the upper bench CD method.

Centrifuge modelling of twin-tunnelling induced ground movements in loess strata

Ground Displacements Due to the Deformations of Shallow Tunnels with Arbitrary Cross Sections in Soft Ground

Effects of Twin Tunneling Underneath on Existing Shield Tunnels

Measurement on Soil Deformation and Numerical Simulation During Tunneling Process

Soil deformation induced by overlapping tunneling in water-bearing strata

Centrifuge modelling of tunnelling below existing twin tunnels with different types of support

Complex Variable Solutions for Tunneling-Induced Ground Movement

Physical modeling of wetting-induced collapse of shield tunneling in loess strata

Relating twin-tunnelling-induced settlement to changes in the stiffness of soil

Experimental and Numerical Investigation on the Effects of Foundation Pit Excavation on Adjacent Tunnels in Soft Soil

Deformation behavior and damage characteristics of surface buildings induced by undercrossing of shallow large-section loess tunnels

Analysis of Influence of Deformation Modes of Retaining Structures on Deformation of a Side Shield Tunnel

Centrifuge Model Test Study on the Behavior of a Tunnel Under the Neighboring Excavation

Analysis of deformation and spatio–temporal effects during construction of a shallow-buried large cross-sectional loess tunnel

Study of Deformation Behaviors and Mechanical Properties of Central Diaphragm in a Large-Span Loess Tunnel by the Upper Bench CD Method

Ground Deformation Characteristics Induced by Mechanized Shield Twin Tunnelling along Curved Alignments

RESEARCH ON SOIL DEFORMATION INDUCED BY OVERLAPPED TUNNELING IN STRATUM SOIL

Influence spatial behavior of surface cracks and prospects for prevention methods in shallow loess tunnels in China

Effect of the longitudinal local wetting-induced collapse on tunnel structure in loess strata

Large-scale geo-mechanical model tests for stability assessment of super-large cross-section tunnel

Effects of Large-Scale Twin Tunnel Excavation on an Existing Pile Group: Three-Dimensional Centrifuge Modeling