Abstract:Polymers and Polymer Composites, Volume 32, Issue , January-December 2024. The variability of microstructures in the SMC composite induced by the manufacturing process is very important. The volumetric fraction and reinforcement orientation distribution significantly affect the material's mechanical properties in both the elastic and nonlinear phases, associated with the development of damage phenomena. The distribution of local stresses between the reinforcements and the matrix is conditioned by the privileged orientation of the reinforcements. This, in turn, influences both the elastic mechanical properties and the degradation mechanisms, resulting in a degree of anisotropy. Additionally, SMC composites typically exhibit viscoelastic-damageable behavior. Therefore, it is necessary to characterize the microstructure accurately and comprehensively to effectively manage the mechanical behavior and damage of SMC structures. The research process involved investigating the viscoelastic behavior of randomly oriented Sheet Molding Compound (SMC) composites using Dynamic Mechanical Analysis (DMA) in the glass transition zone. By conducting a thorough analysis of the frequency and temperature-dependent behavior of the viscoelastic material, the experimental results obtained from the DMA test have been modeled. To demonstrate the effect of the matrix, two types of SMSs were utilized: standard SMC and Advanced SMC (A-SMC). The Cole-Cole experimental results fit well with the Perez model showing deformed semi-circles denoting the heterogeneity of the material system used in this study. The aim of this study is to link the WLF Law to the Perez model near the transition zone. The results demonstrated that dynamic properties can be plotted against temperature due to the strong correlation between the experimental and numerical data. Additionally, an increase in the strain rate results in a shift in the damage threshold and a reduction in damage kinetics. These effects are directly related to the damage thresholds and kinetics at the fiber-matrix interface.

Rheological In-Mold Measurements and Characterizations of Sheet-Molding-Compound (SMC) Formulations with Different Constitution Properties by Using a Compressible Shell Model

Non-isothermal direct bundle simulation of SMC compression molding with a non-Newtonian compressible matrix

Quantification of the Influence of Charge Variations on the Flow Behavior of Sheet Molding Compounds

Numerical investigation of the effects of chopped carbon fiber bundle dimensions on properties of sheet molding compound

A 2D modeling approach for fluid propagation during FE-forming simulation of continuously reinforced composites in wet compression moulding

Viscoelastic-damageable behavior of sheet molding compound (SMC) composites

Numerical modelling and experimental validation of squeezing flows in the automobile production

Characterization and modeling of fatigue behavior of chopped glass fiber reinforced sheet molding compound (SMC) composite

The strain-rate-dependent tensile failure and energy-absorbing behavior of sheet molding compounds

Optimization of precharge placement in sheet molding compound process

Optimizing Epoxy Molding Compound Processing: A Multi-Sensor Approach to Enhance Material Characterization and Process Reliability

Thermomechanical Constitutive Models of Shape Memory Polymers and Their Composites

Modeling the Thermomechanical Behaviors of Short Fiber Reinforced Shape Memory Polymer Composites

Studying the Thermomechanical Behavior of Sm Composites with Aligned Sma Short Fibers by Micromechanical Approaches

Experimental and Numerical Analysis of the Deformation Behavior of Adaptive Fiber-Rubber Composites with Integrated Shape Memory Alloys

Modeling of structural reaction injection molding. Part II: Comparison with experimental data

Injection molding simulation of short fiber reinforced thermosets with anisotropic and non-Newtonian flow behavior

On the relevance of modeling viscoelastic bending behavior in finite element forming simulation of continuously fiber reinforced thermoplastics

Numerical simulation with experimental validation of the structural reaction injection moulding of 3D continuous fibre reinforced polyurethane foam

An Anisotropic Visco-Hyperelastic Model for Thermally-Actuated Shape Memory Polymer-Based Woven Fabric-Reinforced Composites

Investigation and Validation of a Shape Memory Alloy Material Model Using Interactive Fibre Rubber Composites