Abstract:The dominating hydrocarbon pool species (HCPs) in zeolitesformethanol-to-olefin (MTO) conversion have been the subject of intensedebate for decades due to the diversity of structures and the complexityof reaction networks. We performed microkinetic simulations in a three-sitemodel to study the MTO conversion in industrially relevant H-SAPO-34zeolite under a wide range of operating conditions. The energeticsof 229 and 342 elementary reaction steps were employed, respectively,in the aromatic-based and olefin-based cycles. The dynamic distributionand evolution of the retained aromatic or olefinic HCPs and the originof olefin products were revealed with respect to reaction conditions.We corroborate that the olefin-based cycle dominates the MTO conversionin H-SAPO-34 under most reaction conditions, and the contributionof the aromatic-based cycle increase with increasing temperature,decreasing pressure, and/or decreasing water partial pressure. Theparing route, dedicated highly to propene formation, prevails in thearomatic-based cycle; the side chain route, favoring exclusively etheneformation, only prevails at extremely lower temperatures, higher pressures,and higher water contents. The inherent activity of each aromaticHCP via the paring cycle increases, while its population retainedin H-SAPO-34 usually decreases, with the methylation degree remarkablyfrom tetramethylbenzene to hexamethylbenzene. The contents of highermethylbenzenes increase with decreasing water partial pressure, leadingto the enhanced contribution of the aromatic-based cycle. The olefin-basedcycle contributes to the formation of both ethene and other olefins,and the product distribution is drastically sensitive to reactionconditions. Ethene predominantly comes from the cracking of C-5 and C-6 species, and propene comes from C-5 to C-7 species. The olefin-based cycle shifts from theinterconversion of C-2-C-7 olefins towardC(2)-C-5 ones with increasing temperatureand water partial pressure to enhance ethene formation. Under industriallyrelevant conditions, the conversion rate of methanol via the olefin-basedcycle is 40-fold greater than that via the aromatic-based cycle (6.6vs 0.15 s(-1)), and the former agrees unexpectedlywith the experimental value in low-silica AlPO-34 (7.0 s(-1)). This work thus solves the puzzle of dominating HCPs as a functionof reaction conditions in H-SAPO-34 and provides mechanistic insightsinto the kinetic behaviors, which are the basis for the optimizationof the MTO catalyst and process.

Kinetic modeling and laboratory investigation of catalytic toluene methylation to para-xylene

Kinetic Model and Simulation Analysis for Toluene Disproportionation and C9-Aromatics Transalkylation

Study on Complex Reaction Network and Kinetic Model of a Methanol to Propene Process

A Seven Lumped Kinetic Model for Industrial Catalyst in DMTO Process

Kinetic Perspective on Methanol to Propylene Process Via HZSM-5 Catalyst: Balancing Between Reaction and Diffusion

Optimization of Conditions for Preparation of ZSM-5@silicalite-1 Core–shell Catalysts Via Hydrothermal Synthesis

Multinuclear solid-state NMR characterization of the coke on Mo/Hβ-Al2O3 catalyst for olefin metathesis

An investigation of the catalytic performance of Fe–Mn/Al2O3 nanocatalyst for light olefins production using RSM method and kinetic study

Alkylation of Benzene by Methanol: Thermodynamics Analysis for Designing and Designing for Enhancing the Selectivity of Toluene and Para -Xylene

Kinetic modeling of gas-phase disproportionation and transalkylation of C9 and C10 aromatics over industrial zeolite catalyst

High-performance HZSM-5/cordierite Monolithic Catalyst for Methanol to Propylene Reaction: A Combined Experimental and Modelling Study

Comparative study of the catalytic performance of physically mixed and sequentially utilized γ-alumina and zeolite in methanol-to-propylene reactions

Influence of Catalyst Acidity on Dealkylation, Isomerization and Alkylation in Mta Process

Enhancement of catalytic activity of PAl-NaX catalyst for side-chain alkylation of toluene with methanol: Effects of dehydrogenation component Cu

Experimental and kinetic modelling studies for the design of fixed bed methanol reactor over CuZA catalyst

Promoting Xylene Production in Benzene Methylation Using Hierarchically Porous ZSM-5 Derived from a Modified Dry-gel Route

Catalytic Activity and Reactor Simulation of Methanol to Olefins

Catalytic Study of Methanol-to-Propylene Conversion over Nano-Sized HZSM-5

Catalytic Performance of X Molecular Sieve Modified by Alkali Metal Ions for the Side-Chain Alkylation of Toluene with Methanol

Effects of Silicalite-1 Coating on the p-Xylene Selectivity and Catalytic Stability of HZSM-5 in Toluene Methylation with Methanol

Microkinetic Simulations of Methanol-to-Olefin Conversion in H-SAPO-34: Dynamic Distribution and Evolution of the Hydrocarbon Pool and Implications for Catalytic Performance