Abstract:The opposed-power reciprocating pump has the characteristics of high pressure, large flow, and high efficiency and energy saving. However, due to the special structure of the opposed-power reciprocating pump, existing theoretical methods cannot analyze its dynamic performance. Therefore, this paper proposes a method of analyzing the power end of the opposed-power reciprocating pump. Firstly, according to the working principle and structural characteristics of the traditional plunger pump, the novel and complex structure of the opposed-power reciprocating pump is analyzed by analogy, and the force analysis model of the crankshaft is established. The dynamic analysis model of the Matlab program is used to solve the dynamic load and section stress in the working process, and the variation law of crankshaft load is obtained. The 25 most critical working conditions are selected for analysis, and the most critical station and section of the crankshaft are obtained. With the connection between ANSYS Workbench and Solidworks, the model is imported into ANSYS Workbench, the load on the crank pin is loaded by APDL command flow, and the static analysis of the crankshaft is carried out to obtain the stress and strain of the crankshaft. Finally, the static and fatigue strength of the dangerous section is checked, and it is proven that the strength and stiffness of the crankshaft meet the design requirements. The results show that the dynamic analysis results of the crankshaft under critical working conditions are consistent with the finite element analysis, verifying the rationality of the method and providing a reference for the improvement and optimized design of the crankshaft of the opposed-power reciprocating pump.

Finite Element Analysis of New Crankshaft Automatic Adjustment Mechanism of Pumping Unit

FEM Based Simulation Study on Static and Dynamic Properties of Port Plate in Axial Piston Pump

Strength Analysis and Structure Optimization of the Crankshaft of an Opposed-Power Reciprocating Pump

Study of Automatic Dynamic Balancing System for Engine Crankshaft

Study on the Dynamic Load and Mechanical Property of the Plunger Pump Crankshaft

Finite element analysis for the crankshaft of the piston compressor

Structural Design of a Cross Wobble Plate Driving Axial Piston Pump Based on ADAMS and AMESim Co-simulation

Finite element analysis of a vehicle diesel engine crankshaft

58812 ANALYSIS OF THE PISTON/CYLINDER PAIR OF AXIAL PISTON PUMP BASED ON VIRTUAL PROTOTYPE(Fluid-Structure Interaction in MBS)

Finite Element Analysis on Piston of Axial Piston Pump Based on Virtual Prototype

Multi-body dynamics and finite element method co-simulation for crankshaft dynamical strength analysis

Analysis of Fatigue Performance and Parameter Optimization of Single-turn Crankshaft of Submersible Diaphragm Pump

Simulation and Design of the ZW Type Liquefied Petroleum Gas Compressor Crankshaft

Determination on the Operation Condition of Crankshaft of Diesel Engine and Its Static Strength Analysis

Hydraulic System Design and Simulation of the Forging Manipulator

Thermo-Mechanical Coupling Analysis of the Actuating Mechanism in a High Speed Press

Finite Element Analysis of Reciprocating Sealing Component of Radial Single-piston Pump

The Kinematic Analysis and Parametric Design of Beam Pumping Unit Based on ADAMS

Dynamic Analysis of the Crank and Connecting Rod of Single-Cylinder Gasoline Engine Before and After Adjustment

Component Hcf Research Based on the Theory of Critical Distance and A Relative Stress Gradient Modification

Force Analysis of Engine Crankshaft Based on Finite Element Method