Abstract:The previous research of precision grinding optical glasses with electrolytic in process dressing (ELID) technology mainly concentrated on the action of ELID and machining parameters when grinding, which aim at generating very “smoothed” surfaces and reducing the subsurface damage. However, when grinding spectrosil 2000 and BK7 glass assisted with ELID technology, a deeply comparative study on material removal mechanism and the wheel wear behaviors have not been given yet. In this paper, the micro/nano indentation technique is initially applied for investigating the mechanical properties of optical glasses, whose results are then refereed to evaluate the machinability. In single grit diamond scratching on glasses, the scratching traces display four kinds of scratch characteristics according to different material removal modes. In normal grinding experiments, the result shows BK7 glass has a better machinability than that of spectrosil 2000, corresponding to what the micro/nano indentation vent revealed. Under the same grinding depth parameters, the smaller amplitude of acoustic emission (AE) raw signals, grinding force and grinding force ratio correspond to a better surface quality. While for these two kinds of glasses, with the increasing of grinding depth, the variation trends of the surface roughness, the force ratio, and the AE raw signals are contrary, which should be attributed to different material removal modes. Moreover, the SEM micrographs of used wheels surface indicate that diamond grains on the wheel surface after grinding BK7 glass are worn more severely than that of spectrosil 2000. The proposed research analyzes what happened in the grinding process with different material removal patterns, which can provide a basis for producing high-quality optical glasses and comprehensively evaluate the surface and subsurface integrity of optical glasses.

Mechanical properties of the oxide film on ELID electrolytic copper-based grinding wheel by nanoindentation

Mechanical Properties of Oxide Films on Electrolytic In-process Dressing (ELID) Copper-based Grinding Wheel

Formation Mechanism and Simulation of Oxide Film in Electrodeless ELID Grinding

Oxide film thickness and composite mechanical properties of an ultrasonic-assisted ELID cast-iron-bonded grinding wheel

Mechanical Properties Of Zirconia Thin Films Deposited By Filtered Cathodic Vacuum Arc

Deformation and Fracture Behavior of Electrocodeposited Alumina Nanoparticle/Copper Composite Films

Nanoindentation Characterization of Single-Crystal Silicon with Oxide Film

Mechanical Behavior in the Interior and Boundary of Magnesium Aluminate Spinel (mgal2o4) Grain under Nanoindentation.

Indentation Size Dependent Plastic Deformation of Nanocrystalline and Ultrafine Grain Cu Films at Nanoscale

Indentation behavior of creep-feed grinding induced gradient microstructures in single crystal nickel-based superalloy

Cavitation Effect in Ultrasonic-Assisted Electrolytic In-Process Dressing Grinding of Nanocomposite Ceramics

Effects of creep and oxidation on reduced modulus in high-temperature nanoindentation

Understanding of highly-oriented 3C-SiC ductile-brittle transition mechanism in ELID ultra-precision grinding

EFFECT OF GRAIN SIZE AND HOLDING LOAD ON NANOINDENTATION CREEP OF Cu FILM

Effect of the Thermal Expansion Characteristics of Reinforcements on the Electrical Wear Performance of Copper Matrix Composite

Analysis of the nanoindentation load–displacement curves measured on high-purity fine-grained alumina

Thickness and Grain Size Dependent Mechanical Properties of Cu Films Studied by Nanoindentation Tests

Modeling of Oxide-Film Thickness in Electrolytic In-Process Dressing Grinding with Workpiece Swing

Nanoscratching of copper surface by CeO2

Deformation Analysis of Micro/nano Indentation and Diamond Grinding on Optical Glasses