Abstract:The tribological performance of copper-based powder metallurgical material is much influenced by the interfacial bonding between the components and matrix. By adding Cu-coated or uncoated graphite particles as a lubricant, two types of copper-based powder metallurgical materials were prepared via spark plasma sintering (SPS). The hardness, relative density, and thermal conductivity of the two specimens were firstly measured. Using an inertial braking test bench and temperature measuring instrument, the average friction coefficients, instantaneous friction coefficients, and friction temperatures of the two specimens were tested under different test conditions, and the wear rates were calculated accordingly. Based on the analysis of surface morphologies and elements distribution after the tests, the mechanisms of wear and formation of friction films were discussed. The results show that with the lubricant of Cu-coated graphite, the hardness, relative density, thermal conductivity, and interfacial bonding between the graphite and matrix can be greatly improved. Under the same test condition, the average friction coefficient, wear rate, and friction temperature of the specimen with added Cu-coated graphite are both lower than those of the specimen with added uncoated graphite. The two specimens show different variation trends in the instantaneous friction coefficient during the tests, and the variation of the instantaneous friction coefficient at a high initial test speed is also different from that at a low initial test speed for each specimen. The two specimens also show differences in the continuity of friction film and the content of graphite and oxide in the friction film.

Effect of Cr–Fe on friction and wear properties of Cu-based friction material

Effect of Cu content on the microstructure and properties of sintered Fe-0.8C-xCu antifriction materials

Effect of Iron Powder Type on Friction and Wear Properties of Copper-Based Friction Powder Metallurgy Material

Influence of Fe and Al2O3 Addition on the Mechanical and Tribological Properties of Cu-Based Composites

Effect of Mo-coated MoS2 powder addition on the microstructure and properties of sintered Fe-15Cu-0.8C antifriction materials

Study on the Tribological Performance of Copper-Based Powder Metallurgical Friction Materials with Cu-Coated or Uncoated Graphite Particles as Lubricants

Effect Of Carbon-Fibre Powder On Friction And Wear Properties Of Copper-Matrix Composites

Effects of Fe and graphite on friction and wear properties of brake friction materials for high-speed and heavy-duty vehicles

Effect of Reinforcement on the Tribological Behavior of CuFe-Based Composites

Wear Mechanism of Copper-based Powder Metallurgical Friction Materials with Different Graphite Content

Influence of Cr Addition on Tribological Properties of Bulk Fe2B under Dry Friction and Water Lubrication

The Microstructure and Wear Characteristics of Cu–Fe Matrix Friction Material with Addition of SiC

Microstructure, mechanical and tribological properties of Cu-Sn/Cr3C2/Gr composites

Braking Performance of Copper-Based Friction Materials Reinforced by AlCoCrFeNi High-Entropy Alloy

Mechanical and tribological property of Cu/CrB 2 composites under dry sliding condition

Effect of Added Fe Element on Microstructure of CuCr Contact Materials

Effect of Type and Content of Iron Powder on the Formation of Oxidized Film and Tribological Properties of Cu-matrix Composites

Mechanical and tribological properties of FeS/Cu–Bi self-lubricating materials reinforced with copper-plated steel fibers

Study on the tribological properties of MoB/Cu laminated composite materials fabricated by hot-pressing process

Friction and wear behavior of CuFe3Al powder metallurgical composites in dry sliding

Effect of copper on structure and properties of sintered iron-based antifriction materials