Abstract:<p>Rock abrasivity is an important factor that affects tool wear and tool parameter design, construction efficiency, and cost budgeting during rock excavation. The Cerchar abrasivity index (CAI) is used as a standard parameter to characterize the abrasiveness of rocks. It can be obtained through the Cerchar abrasivity test in a laboratory. However, conventional laboratory Cerchar abrasivity tests and petrophysical and mechanical tests are associated with certain problems, such as long cycles, high costs, and measurement delays, which cannot serve the determination of rock abrasiveness in field. Digital drilling technology is an efficient in situ test method that can effectively link drilling parameters with rock properties. Based on the test results for the CAI and physical and mechanical properties of 13 groups of rock samples collected from southwestern China, this paper focuses on the correlations of the CAI value with rock strength, petrographic characteristics and drilling parameters. By adopting a flat bottom diamond bit that mainly relies on grinding, according to the principle of mechanical balance and energy conservation during rock drilling, the grinding energy per unit volume of rock (ηe) is defined and derived. The univariate regression analysis results show that the uniaxial compressive strength (UCS) and equivalent quartz content (EQC) are the most important factors for explaining CAI and that the CAI can be well estimated using the ηe. Additionally, two optimal regression models for predicting CAI were established using stepwise multiple regression analysis. UCS and ηe were introduced into the model, and the use of both can predict approximately 96% of the variance in the CAI. In addition, a performance evaluation of the models proposed in this paper and previously published CAI prediction models that the prediction models established in this paper are verify statistically more reasonable and reliable than the previously proposed models. The research methods and results provide a new method for the rapid and accurate determination of rock abrasiveness in engineering field.</p>

Effects of variation in the particle size of the rock abrasion powder and standard rotational speed on the NTNU/SINTEF abrasion value steel test

Experimental Investigation of Correlation Between Attrition Wear and Features of Acoustic Emission Signals in Single-Grit Grinding

Evaluation of Granular Soil Abrasivity for Wear on Cutting Tools in Excavation and Tunneling Equipment

A Critique on the Correlations Between Rock Abrasiveness, Hardness, and Mechanical Characteristics: Implication of LCPC Abrasiveness and Breakability Coefficients

Evaluating the Relationships Between NTNU/SINTEF Drillability Indices with Index Properties and Petrographic Data of Hard Igneous Rocks

Effect of Water Content on the Abrasivity of Granular Soils in Soft Ground Tunneling Applications

Effect of abrasive particle size and the influence of microstructure on the wear mechanisms in wear-resistant materials

Investigation on the relationship among the Cerchar abrasivity index, drilling parameters and physical and mechanical properties of the rock

Computational Simulation and Experimental Analysis on Wearing Mechanisms of Gypsum and Concrete Samples in Pin‐on‐Disk ASTM Abrasion Testing

Experimental Investigation on the Influence Factors on TBM Cutter Wear Based on Composite Abrasion Test

Determination of Internal Friction Angle of Rocks Using Scratch Test with a Blunt PDC Cutter

Experimental investigation of abrasive potential and drilling efficiency at elevated temperatures via Cerchar rock scratching

New soil abrasion testing method for evaluating the influence of geological parameters of abrasive sandy ground on scraper wear in TBM tunneling

Experimental investigation of the failure of conical picks under thermal and abrasive effects

Classifications of properties influencing the drillability of rocks, based on the NTNU/SINTEF test method

Wear of Cutting Tools in Hard Rock Excavation Process: A Critical Review of Rock Abrasiveness Testing Methods

Experimental and ANN Analysis of Shearing Rate Effects on Coarse Sand Crushing

Abrasivity measurement of brittle rock after thermal treatment

Effects of Soil Conditioning on Tool Wear for Earth Pressure Balance Shield Tunneling in Sandy Gravel Based on Laboratory Test

SURFACE MODIFICATION OF SPRING TINE CULTIVATOR POINTS WITH DIFFERENT METAL POWDERS BY GTAW METHOD