Abstract:The static drill rooted nodular (SDRN) pile is a new type of composite pile that consists of a precast pile and surrounding cemented soil. Its cost advantages and environmentally friendly construction have been proven in applications in Southeast China. Moreover, the composition of pipe pile and nodular pile is based on the load transfer mechanisms of a pile foundation, which is effective in optimal design. This paper presents a field study on the behavior of SDRN piles under compression. The load-displacement response, axial force, mobilized load of pile cap, skin friction, and tip resistance of the composite pile are discussed. Here, the bilinear base load-displacement model was adopted to analyze the test results. It is found that providing caps on the static drill rooted piles takes full advantage of the static drill rooted method, and drilling and grouting into the soil beneath the cap, which can be considered a type of ground improvement treatment, can increase the bearing capacity of the pile cap; thus, setting a pile cap for this type of piles is recommended. The existence of the caps in the field tests decreased the skin friction of the upper part of pile shaft because of the additional settlement of the surrounding soil, which developed owing to the pressure from the caps. The frictional capacity of the concrete-cemented soil interface was much higher than that of the cemented soil-soil interface. The skin friction of the lower part of the pile shaft was about 1.25 times in clayey soil and 2.0 times in sandy soil compared with the bored pile. It can be concluded that the cemented soil-soil interface of the SDRN pile was probably better than the concrete-soil interface of the bored pile. The test results fitted the first stage curve of the bilinear model well, and it can be supposed that the base soil was strengthened because of the permeation of the cement paste.

Static and Dynamic Load Tests of Shaft and Base Grouted Concrete Piles

ANALYSIS OF RESIDUAL STRESS ON PILE-BASE POST GROUTING PILE

Assessment of design methods for axial bearing capacity of driven piles in clay

Model Test Study of Bearing Behavior of Small Prefabricated Piles in Soft Soil Area

A Novel Method for Testing the Effect of Base Post-Grouting of Super-Long Piles

Model Tests on the Bearing Capacity of Precast Open-Ended Micro Pipe Piles in Soft Soil

Testing and Modeling the Behavior of Pre-Bored Grouting Planted Piles under Compression and Tension

Experimental study on vertical bearing performance of base post-grouted cast-in-place plies in soft soils

Model tests comparing the behavior of pre-bored grouted planted piles and a wished-in-place concrete pile in dense sand

A Field Study on the Behavior of Static Drill Rooted Nodular Piles with Caps under Compression

Field study on the behavior of pre-bored grouted planted pile with enlarged grout base

A test on base bearing capacity of static drill rooted nodular pile

Vertical Bearing Capacity of Large-Diameter Bored Pile

A Simplified Nonlinear Calculation Method to Describe the Settlement of Pre-Bored Grouting Planted Nodular Piles

Bearing Capacity And Load Transfer Mechanism Of Static Drill Rooted Nodular Piles

Effect of Cemented Soil Properties on the Behavior of Pre-Bored Grouted Planted Nodular Piles under Compression

Shaft Capacity of the Pre-Bored Grouted Planted Pile in Dense Sand

Field Behavior of Pre-Bored Grouted Planted Nodular Pile Embedded in Deep Clayey Soil

Field Tests on Behavior of Pre-Bored Grouted Planted Pile and Bored Pile Embedded in Deep Soft Clay

Experimental Study on Post-Grouting Pile Vertical Bearing Performance Considering Different Grouting Methods and Parameters in Cohesive Soil

Laboratory tests on the frictional capacity of core pile - cemented soil interface