Abstract:Biogas dry reforming or dry reforming of methane (DRM) is an alternative to produce hydrogen, in the context of development of sustainable routes for energy production, since this route uses CH 4 and CO 2 , two greenhouse gases as reactants. However, the deactivation of catalysts due to carbon deposition and sintering is the main drawback of this reaction. In this work, with the aim of minimizing carbon formation and sintering during DRM, the effect of lithium as a promoter in catalysts Ni–Al derived from layered double hydroxides was investigated. The catalysts were prepared by co-precipitation and characterized by different techniques: BET surface area (S BET ), X-ray diffraction (XRD), temperature-programmed reduction (TPR), CO 2 and H 2 temperature-programmed desorption (CO 2 -TPD and H 2 -TPD), Scanning Electron Microscopy (SEM-EDS), temperature-programmed oxidation (TPO). The catalytic tests were carried out in a fixed bed reactor using a synthetic biogas (60% CH 4 and 40% CO 2 ) in the temperature range of 500–750 °C. The incorporation of Li into the Ni–Al-LDH changed the reducibility and basicity of the catalysts. The Li2 sample containing an intermediary amount of Li (5 wt%) showed the highest reduction temperature and highest density of basic sites, which resulted in the smallest Ni crystallite size before and after the reactions. As a result, this catalyst presented the greater resistance to sintering and a lower rate of carbon produced. For the reaction carried out at 700 °C, only the Li2 catalyst remaining active during the test and reaching a maximum of 80% and a final CH 4 conversion of 54% after 480 min of reaction, whereas CO 2 conversion was higher than 90%. All other samples deactivated at different rates due to carbon deposition and sintering.

Catalyst Deactivation and Regeneration Processes in Biogas Tri-Reforming Process. The Effect of Hydrogen Sulfide Addition

Deactivation and Regeneration of Raney-Ni Catalyst During Multiphase Dehydrogenation of Cyclohexane

Deactivation and Regeneration Method for Ni Catalysts by H2S Poisoning in CO2 Methanation Reaction

Experimental Study on Sulfur Deactivation and Regeneration of Ni-Based Catalyst in Dry Reforming of Biogas

Dry Reforming of Model Biogas on a Ni/SiO2 Catalyst: Overall Performance and Mechanisms of Sulfur Poisoning and Regeneration

Sulfur Poisoning Mechanism of Steam Reforming Catalysts: an X-ray Absorption Near Edge Structure (XANES) Spectroscopic Study.

Regeneration of methane splitting catalysts by interfacial hydrogenation

Influence of H2S and NH3 on biogas dry reforming using Ni catalyst: a study on single and synergetic effect

H2SO4 Poisoning of Ru-based and Ni-based Catalysts for HI Decomposition in Sulfur Iodine Cycle for Hydrogen Production

Deactivation and Regeneration for the SO2-Poisoning of a Cu-SSZ-13 Catalyst in the NH3-SCR Reaction

Spontaneous regeneration of active sites against catalyst deactivation

Catalytic and Sulfur-Tolerant Performance of Bimetallic Ni-Ru Catalysts on HI Decomposition in the Sulfur-Iodine Cycle for Hydrogen Production

Deactivation Mechanism Study for Sulfur-Tolerance Enhanced NiO Nanocatalysts of Lean Methane Oxidation

New insight and countermeasure for sulfur poisoning on nickel-based catalysts during dry reforming of methane

Regeneration of Selective Catalyst Reduction Catalysts Deactivated by Pb, As, and Alkali Metals

Hydrogen reverse spillover eliminating methanation over efficient Pt-Ni catalysts for water-gas shift reaction

Deactivation and in-situ regeneration of Dy-doped Ni/SiO2 catalyst in CO2 reforming of methanol

Biogas dry reforming over Li–Ni–Al LDH-derived catalysts

Swapping Catalytic Active Sites from Cationic Ni to Anionic S in Nickel Sulfide Enables More Efficient Alkaline Hydrogen Generation

Effect of Re Addition on the Water–Gas Shift Activity of Ni Catalyst Supported by Mixed Oxide Materials for H2 Production

Biogas Upgrading by CO2 Methanation with Ni-, Ni–Fe-, and Ru-Based Catalysts