Abstract:High performance multiphase motor drive requires precise knowledge of the state quantities and the machine parameters. Access to these state quantities is through measurement using sensors whose accuracy is paramount to achieve the performance level required by industrial applications. However, the problems of the parameters variations, inaccessibility to the measurement of some states, no-observability of the machine in some regions, the cost of the sensors and their lack of precision, make this very difficult task. To address these problems, it is necessary to resort to soft sensors through the design of observers and estimators. In multiphase induction motor drive, the observation problem arises especially for rotor flux that is not accessible for measurement. About the parameters variations, the rotor resistance and the stator resistance are the most critical parameters of the machine because their influence is crucial for the control and observation. The change in the resistances can be as large as 40–50% of the rated value, which may affect the control adversely. This paper develops a new structure of an adaptive sliding mode observer based on an online estimation of the rotor resistance value in order to avoid the effect of its variation in the rotor flux oriented control. The results show convergent (the errors in the transient and steady states are 5% and 1%, respectively) behavior of the drive using the proposed control scheme for large rotor resistance variation under loaded condition. The stability of the drive is proved using Lyapunov criteria. The simulation results are validated using real time implementation.

Experimental Investigation of Passive Fault Tolerant Control for Induction Machine Using Sliding Mode Approach

A Fault Tolerant Control Strategy for Dual Three-Phase PMSM under Single-Phase Open Circuit Fault Considering Inductance Asymmetry

Sliding Mode Sensor Fault Tolerant Control Structure for Induction Motor

Sliding mode based fault detection, reconstruction and fault tolerant control scheme for motor systems

Fault-Tolerant Control Based on Sliding Mode Controller for Double-Star Induction Machine

Sensorless Fault-Tolerant Control Of Multiphase Induction Machine Using Virtual Winding And Adaptive Observer

Fault-Tolerant Control of Five-Phase Induction Motor under Single-Phase Open

Induction motor fault detection by a new sliding mode observer based on backstepping

Position Control of the Induction Motor Using an Adaptive Sliding-Mode Controller and Observers

Adaptive Discrete-Time Quasi-Sliding Mode Control of Induction Motors

A New Control Strategy of 5-Phase PM Motor under Open-Circuited Phase Based on High Order Sliding Mode and Current References Real-Time Generation

Feedback linearization based sensorless direct torque control using stator flux MRAS-sliding mode observer for induction motor drive

Current Sensor Fault Diagnosis Based on a Sliding Mode Observer for PMSM Driven Systems

Real time implementation of indirect rotor flux oriented control of a five-phase induction motor with novel rotor resistance adaption using sliding mode observer

Sensorless nonlinear sliding mode control of the induction machine at very low speed using FM-MRAS observer

High Order Sliding Mode Optimal Current Control of Five Phase Permanent Magnet Motor under Open Circuited Phase Fault Conditions

Integral Sliding Mode Control for Improved Robustness and Accuracy of Induction Motors

Current sensor fault‐tolerant control strategy for surface‐permanent‐magnet‐synchronous motor drives based on improved full‐order sliding‐mode observer

Active Fault Tolerant Nonsingular Terminal Sliding Mode Control for Electromechanical System Based on Support Vector Machine

Super-Twisting MRAS Observer-Based Non-linear Direct Flux and Torque Control for Induction Motor Drives

A novel fault tolerant control approach based on backstepping controller for a five phase induction motor drive: Experimental investigation