Abstract:Multisector in-wheel motors have been widely used in the fields of electric vehicles and electric aircraft due to their high torque density, high power, and strong reliability. As the core component of the current controller and various observers, the current sensor plays a vital role in the stable control of the motor, thus the fault diagnosis and fault-tolerant control of current sensors is essential. However, the characteristics of both single-phase open-circuit faults and current sensor break faults are similar, making it difficult to distinguish between the two faults. In addition, for current sensor faults, the winding is usually directly cut off and controlled as a phase fault condition, which limits the output capability of the system. How to fully utilize the healthy windings after the current sensor fault is critical. Aiming at the above problems, this paper firstly analyzes the differences in the mechanism of current sensor fault and phase break fault and proposes a fault diagnosis algorithm based on a neutral point voltage observer. Secondly, to improve the robustness of the proposed method under the inaccurate motor parameters, an improved diagnostic algorithm by compensating the neutral voltage observation of the health sector is proposed. Finally, for fault-tolerant operation after current sensor failure, an extended Kalman observer which integrates the information of healthy and faulty sectors is proposed to realize the observation of faulty-phase current and fault-tolerant operation. The experiments with a four-sector in-wheel motor drive finally prove the evidence of the proposed algorithm.

Sensorless Fault-Tolerant Control Of Multiphase Induction Machine Using Virtual Winding And Adaptive Observer

A Fault Tolerant Control Strategy for Dual Three-Phase PMSM under Single-Phase Open Circuit Fault Considering Inductance Asymmetry

Sensorless Control Strategy for Multiphase Induction Motor with Stator and Rotor Resistance Identification Based on Injecting Third Harmonic Current

Sensorless Vector Control of Multiphase Induction Machine Based on Full-Order Observer and Harmonic Suppression

Fault-tolerant Control of Multiphase Induction Machine Drives Based on Virtual Winding Method

Fault Tolerant Control of a Multiphase Motor with Non-Sinusoidal Source under Open-Phase Conditions

Strategies for the fault-tolerant current control of a multiphase machine under open phase conditions

Single- and Two-Phase Open-Circuit Fault Tolerant Control for Dual Three-Phase PM Motor Without Phase Shifting

Fault-Tolerant Control of Five-Phase Induction Motor under Single-Phase Open

Position Sensorless Control Based on Sliding Mode Observer for Multiphase Bearingless Motor with Single Set of Windings

Research of Sensorless Control for Multiphase Induction Motor Based on High Frequency Injection Signal Technique

Online Decoupled Stator and Rotor Resistances Adaptation for Speed Sensorless Induction Motor Drives by a Time-Division Approach

Fault Tolerant Control of Harmonic Injected Nine-Phase Flux Switching Permanent Magnet Motor Drive System

Sensorless Control for Five-phase Induction Motors With Improved Third-harmonic Current Injection

Speed-Sensorless Induction Machine Control in the Field-Weakening Region Using Discrete Speed-Adaptive Full-Order Observer

Enhanced Rotor Field-Oriented Control of Multiphase Induction Machines Based on Symmetrical Components Theory

Position sensorless control of five-phase BLDC motor under single-phase open circuit fault

A Novel Square-Wave Voltage Injection Based Sensorless Control Method Robust to Single Open-Phase Fault for Dual Three-Phase IPM

Sensorless control for five-phase PMSMs under normal and open-circuit fault conditions using super-twisting sliding mode observers

An Improved Current Sensor Fault Diagnosis and Fault-tolerant Control for Multisector Permanent Magnet Synchronous Motor

Sensorless Fault-Tolerant Control of Dual Three-Phase Permanent Magnet Synchronous Motor