Abstract:Currently, there is a growing emphasis on wastewater reclamation and reuse all over the world due to restricted water resources. Among a variety of wastewater reuse technologies, the use of microfiltration membranes (MF) is one of the popular processes because it has the ability to successfully eliminate particulates and colloidal matters. However, successful fouling control is not easy because effluents from the activated sludge process still contain small particulates and colloidal matters such as extracellular polymeric substance (EPS) and soluble microbial products (SMP). On the other hand, microbubbles have advantageous properties compared to common bubbles, but there hasn’t been reporting of the use of microbubbles in physical cleaning instead of aeration. Encouraging results were obtained herein through the application of microbubbles for physical cleaning. In evaluation of the cleaning efficiency, the efficiency of microbubbles was observed to be twice as high as that of aeration, except during the course of the initial 30 min. Total organic carbon (TOC) concentration of the membrane tank after treatment with microbubbles was more than twice as high as that after aeration for physical cleaning. The membrane cleaned with microbubbles also had the smoothest surface, with a roughness of 42.5 nm. In addition, microbubbles were found to effectively remove EPS and make the structure of the gel layer loose. In particular, the microbubbles had the ability to remove proteins through the effect of pyrolytic decomposition. Therefore, in FT-IR spectra of the membrane surfaces taken before and after physical cleaning, while each treatment showed similar peak positions, the peak values of the membrane treated with microbubbles were the lowest. Through various analyses, it was confirmed that microbubbles can remove foulants on the gel layer in spite of their very low shear force. This means that microbubble cleaning has full potential for use as a physical cleaning method in the wastewater reclamation process.

Fundamental Properties of Microbubble in Semiconductor Cleaning Technology

Experimental Analysis of Initiation Mechanism of Bubbles in Ultra-Clean Pumps Circulating Hydrogen Peroxide

Acoustic bubble array-induced jet flow for cleaning particulate contaminants on semiconductor wafers

Degreasing of Solid Surfaces by Microbubble Cleaning

Electrochemical investigations of stable cavitation from bubbles generated during reduction of water

Micro Bubble Generation with Pressurized Droplet from Ultra Fine Bubble Water and Its Cleaning Effect

Emergence of debubblers in microfluidics: A critical review

Bubble Removal in Viscoelastic Solution by Ultrasonic Vibration

Removal of Surface-Attached Micro- and Nanobubbles by Ultrasonic Cavitation in Microfluidics

Influence of microbubble in physical cleaning of MF membrane process for wastewater reuse

Impact of Water Purity and Oxygen Content in Gas Phase on Effectiveness of Surface Cleaning with Microbubbles

Environment-friendly surface cleaning using micro-nano bubbles

Production of Monodispersed Micron-Sized Bubbles at High Rates in A Microfluidic Device

Non-contact removal of 60-nm latex particles from silicon wafers with laser-induced plasma

Air trap and removal on a pressure driven PDMS-based microfluidic device

Microbubble-Assisted Cleaning To Enhance the Removal of Milk Deposits from the Heat Transfer Surface

Micro and nano-sized bubbles for sanitation and water reuse: from fundamentals to application

Removing proteins or bacteria on a tilted surface using air bubbles

Research on the Mechanism and Control Strategy of Microbubble Cleaning Sludge

Exposing nanobubble-like objects to a degassed environment

Green Cleaning of 3D-Printed Polymeric Products by Micro-/Nano-Bubbles