Abstract:Compared to cross-linked polyethylene, polypropylene has a thermoplastic property and the advantage of recycling. However, the poor impact resistance at low temperature and the corresponding space charge problem restrict the application of polypropylene with the extruded high voltage direct current (HVDC) cable. Sufficient introduction of the β form of the polypropylene crystal can significantly improve impact resistance at low temperatures. Although it has been widely applied in insulation engineering, the effect of β-crystal on the space charge characteristics of polypropylene has rarely been researched until now. In this paper, a rare earth nucleating agent of β-crystal is employed to modify the performance of polypropylene to investigate the effects of nucleating agent content on β-crystalline, mechanical relaxation, trap, and space charge characteristics of polypropylene. The results of differential scanning calorimeter (DSC) and X-ray diffraction (XRD) tests indicate that the relative content of β-crystal in modified polypropylene increases gradually with the increasing concentration of the nucleating agent, approaching 43.5% when the nucleating agent content has been raised to 0.2 wt %, suggesting appreciable efficiency of the nucleating agent utilized in our research. Scanning electron microscopy (SEM) is utilized to characterize the morphology of β-crystal spherulites, which illustrates that the β-spherulites are in bunchy shape, and the lamellar crystals are parallel to each other without an obvious boundary between them. The results of the space charge test demonstrate that the modified polypropylene can substantially suppress space charge accumulation, which is attributed to an increment of β-crystal content by adopting a rare earth nucleating agent. It is indicated from dynamic mechanical analysis (DMA) measurements that the enhancement of β-crystalline in modified polypropylene can distinctly increase and decrease the β and α relaxation losses, respectively, which proves that the defects in β-crystal and amorphous regions are reduced and increased respectively. Thermally stimulated depolarization current tests further confirm that the number of traps caused by defects in the β-form of polypropylene crystal declines definitely, which dominantly accounts for the suppression of space charge accumulation.

High improvement in trap level density and direct current breakdown strength of block polypropylene by doping with a β-nucleating agent

High Improvement In Trap Level Density And Direct Current Breakdown Strength Of Block Polypropylene By Doping With A Beta-Nucleating Agent

Electrical Property of Polypropylene Toughened by β Nucleating Agent

Space Charge Characteristics of Polypropylene Modified by Rare Earth Nucleating Agent for β Crystallization

Enabling High-Performance Polypropylene Nanocomposites With Interfacial Deep Traps

Morphology and Crystalline-Phase-Dependent Electrical Insulating Properties in Tailored Polypropylene for Hvdc Cables

Effect of Β-Crystals on the Mechanical and Electrica Properties of Β-Nucleated Isotactic Polypropylene

Improvement of space charge suppression of polypropylene for potential application in HVDC cables

Enhanced Electrical Tree Resistance of Polypropylene Cable Insulation by Introducing β-Crystals

Large Improvement in Trap Level and Space Charge Distribution of Polypropylene by Enhancing the Crystalline − Amorphous Interface Effect in Blends

Electrical conduction properties of PP-based nanocomposite with high thermal conductivity for HVDC cable insulation

Temperature dependent electrical properties of thermoplastic polypropylene nanocomposites for HVDC cable insulation

Enhanced Dielectric Breakdown Property of Polypropylene Based on Mesoscopic Structure Modulation by Crystal Phase Transformation for High Voltage Power Cable Insulation

Polypropylene nanocomposites doped with carbon nanohorns for high-voltage power cable insulation applications

Enhanced Electrical Insulation Properties of 2-isopropenyl-2-oxazoline Grafted Polypropylene for High Voltage Direct Current Power Cables

Trap Distribution and Direct Current Breakdown Characteristics in Polypropylene/Al2o3 Nanodielectrics

Improved Insulation Properties of Polypropylenes in HVDC Cables Using Aqueous Suspension Grafting

Voltage Stabilizer Grafted Silica Nanoparticles for Significantly Enhanced Breakdown Strength Potential Thermoplastic Polypropylene Insulation

High thermal conductivity and excellent electrical insulation performance in double-percolated three-phase polymer nanocomposites

Dielectric Properties Improvement of Grafting-Modified Polypropylene by Silane for HVDC Cable Insulation