Abstract:Critical Dimension measurement in the final slider-level fabrication is essential in the development and manufacture of magnetic read/write heads for hard disk drives (HDD). It validates the device level geometry that plays a dominant role in the magnetic performance of the writer and provides critical feedback to the wafer-level head fabrication process control. Measurement at the slider-level affords the true Air Bearing Surface (ABS) view of the real device that can only be approached by the destructional cross-section at wafer level [1,2]. While the large set of CDSEM images of writer ABS at slider level enables an excellent statistical view of wafer uniformity, it also poses special challenges to the metrology due to a substantial number of variations from the upstream wafer process. The large structure variations observed at the sliderlevel is particularly prevalent in the initial development phase where large DOE (Design of Experiment) are designed to produce intended structure variations, and low process maturity yields large unintended variations among the devices. A traditional metrology used in such a variant data set requires extensive tuning or even a set of separate solutions with each solution in the set only applicable to a small subset of the variations. However, this approach is inefficient and demands high engineer resources. In this work, we use a machine learning based metrology approach to process the large set of magnetic writer device images at the slider level. For the current study, we use a model-based solution that was trained with deep learning (DL) using a dataset from 4 different head designs. The model aims to retrieve precise boundaries of the head to perform accurate measurements. We demonstrate the progressive robustness of the model-based solution by expanding the training set to measure the CD of writer poles with different designs and large process variations due to the intrinsic wafer level structure variation and the image distortions from the slider fabrication process. In addition, we will demonstrate the efficiency of the Deep Learning (DL) based solution in comparison with traditional metrology and manual measurements on the same set of data.

CD-SEM real time bias correction using reference metrology based modeling

Limits of model-based CD-SEM metrology

Diagnosing and removing CD-SEM metrology artifacts

Just-In-Time Modeling with Variable Shrinkage Based on Gaussian Processes for Semiconductor Manufacturing

Uncertainty evaluation of Monte Carlo simulated line scan profiles of a critical dimension scanning electron microscope (CD-SEM)

An Optimized Parameter Guidance System for Line/Space CD Metrology

Sidewall angle calculation on CD-SEM metrology

Evolution of lithography-to-etch bias in multi-patterning processes

Introducing machine learning-based application for writer main pole CD metrology by dual beam FIB/SEM

Advanced CD-SEM solution for edge placement error characterization of BEOL pitch 32nm metal layers

Application of Machine Learning Method to Model-Based Library Approach to Critical Dimension Measurement by CD-SEM

Geometric Analysis of Measurement Errors in a Surface Metrology Class with Closed-Loop Probes

A novel flow of full-chip OPC model calibration and verification by utilizing SEM image contours

Application of machine learning-based metrology for writer main pole CD measurement by CDSEM

Depth estimation from a single SEM image using pixel-wise fine-tuning with multimodal data

Feasibility of monitoring a multiple e-beam tool using scatterometry and machine learning: stitching error detection

To improve the measure fail rate On SEM through six sigma DMAIC methodology — Chien-Hui Lu

Efficient measurement and optical proximity correction modeling to catch lithography pattern shift issues of arbitrarily distributed hole layer

Virtual metrology for chemical mechanical planarization of semiconductor wafers

Correction of Scanning Electron Microscope Imaging Artifacts in a Novel Digital Image Correlation Framework