Abstract:This study conducted in situ combustion oxidation experiments on crude oil from Block D within the Liaohe Oilfield, utilizing a kettle furnace low-pressure oxidation reaction method at various temperatures. The molecular composition of oxidation products was analyzed using gas chromatography–mass spectrometry (GC–MS) and high-resolution mass spectrometry. The results reveal that the molecular composition of the products remains relatively stable up to 300 °C, exhibiting a slight increase in C13-C30 alkanes. The ratio of the peak area for C21 to bisnorhopane is 0.082. From 300 °C to 450 °C, compounds with long alkyl chains gradually undergo thermal cracking, resulting in a significant increase in the production of alkanes within the C10–C30 range. The concentration of saturated hydrocarbons produced through thermal cracking reaches its maximum at a temperature of 400 °C. The most abundant peak of n-alkane is observed at C21, with a quantified ratio of peak area for C21 to bisnorhopane at 6.5, indicating a two-order magnitude increase compared to crude oil. From 500 °C to 600 °C, compounds undergo more profound thermal cracking and condensation processes. The predominant hydrocarbons consist of aromatic molecules containing two to six rings substituted with short side chains. The double bond equivalent (DBE) values of carbazoles and carboxylic acids are determined as 30 and 25, respectively. At 600 °C, the peak area ratio of naphthalene to biodecane is 300, indicating a remarkable increase of five orders of magnitude compared to the crude oil. The present study elucidates the correlation between the characteristics of combustion components in crude oil and the corresponding combustion temperature. Primary cracking reactions within crude oil are promoted effectively when keeping the combustion zone at 350 °C and 450 °C. This process significantly reduces the viscosity of heavy oil and enhances its fluidity.

The low temperature oxidation characteristics of SARA fractions in air flooding process

Low Temperature Oxidation of Toluene in an N-Heptane/toluene Mixture

Evolution of mass losses and evolved gases of crude oil and its SARA components during low-temperature oxidation by isothermal TG–FTIR analyses

Experimental Study on Low-Temperature-Oxidation Parameters and Simulations of Exothermic Process during Air Injection in Light Oil Reservoirs

Experimental study on dynamic characteristics of low temperature oxidation for Bohai offshore light oil under reservoir conditions

Molecular composition of low-temperature oxidation products of the heavy oil

Isothermal low-temperature oxidation behavior and kinetics of heavy oil

Air Injection for Enhanced Oil Recovery: In Situ Monitoring the Low-Temperature Oxidation of Oil through Thermogravimetry/Differential Scanning Calorimetry and Pressure Differential Scanning Calorimetry

Heat Release Model for the Low Temperature Oxidation of Heavy Oils from Experimental Analyses and Numerical Simulations

The impact of the oil character and quartz sands on the thermal behavior and kinetics of crude oil

Low-temperature oxidation reactions of crude oils using TGA–DSC techniques

Ketones in Low-Temperature Oxidation Products of Crude Oil

Investigation on effect of water on oxidation behaviors and kinetics of heavy crude oil using STA and ARC

Evolution of the Pseudo-Components of Heavy Oil during Low Temperature Oxidation Processes

Effects of SARA fractions on pyrolysis behavior and kinetics of heavy crude oil

Insights for Air Injection EOR from Static Oxidization Behaviours of Crude Oil

SARA-based kinetics model for simulating heat release during crude oil combustion

Oil oxidation in the whole temperature regions during oil reservoir air injection and development methods

In Situ Combustion Characteristics of Heavy Oil in the Liaohe Oilfield at Different Temperatures

Effects of Clay Minerals on the Low-Temperature Oxidation of Heavy Oil

Spontaneous Combustion Behavior of Sulfur Corrosion Products in Oil Tank