Abstract:Electromagnetic testing is the most widely used technique for the inspection of steel wire ropes. As one of the electromagnetic detecting approaches, the magnetic flux leakage (MFL) method has the best effect for the detection of broken wires. However, existing sensors based on MFL method still have some problems. (1) The size of the permanent magnet exciter is usually designed according to experience or rough calculation, and there is not enough depth analysis for its excitation performance; (2) Since the detectable angular range for a single Hall component is limited, Hall sensor arrays are often employed in the design of MFL sensors, which will increase the complexity of the subsequent signal processing due to the extensive use of Hall components; (3) Although the new magneto-resistance sensor has higher sensitivity, it is difficult to be applied in practice because of the requirement of the micron-level lift-off. To solve these problems, a sensor for the detection of broken wires of steel wire ropes based on the principle of magnetic concentration is developed. A circumferential multi-circuit permanent magnet exciter (CMPME) is employed to magnetize the wire rope to saturation. The traditional Hall sensor array is replaced by a magnetic concentrator to collect MFL. The structural parameters of the CMPME are optimized and the performance of the magnetic concentrator is analyzed by the finite element method. Finally, the effectiveness of the designed sensor is verified by wire breaking experiment. 1-5 external broken wires, handcrafted on the wire rope with a diameter of 24 mm, can be clearly identified, which shows great potential for the inspection of steel wire ropes.

Theoretical and experimental research on wire rope magnetic memory testing under weak magnetic excitation

Finite Element Simulation and Test of Metal Magnetic Memory Detection of Wire Rope Under Weak Magnetic Field

Research on Quantitative Detection of Wire Rope Damage Based on Weak Magnetic Excitation

Simulation analysis and experimental investigation of wire rope leakage magnetic field detection

Quantitative Study on Cross Section Damage of Steel Wire Rope Based on Magnetic Signal Characteristics Under Weak Magnetic Excitation

Smart Elasto-Magneto-Electric (EME) Sensors for Stress Monitoring of Steel Cables: Design Theory and Experimental Validation.

A New Magnetic Sensor Based on Giant Magneto- impedance Effect of Fe-based Amorphous Wire

A Sensor for Broken Wire Detection of Steel Wire Ropes Based on the Magnetic Concentrating Principle

Experimental study on Strengthening the magneto-mechanical Coupling Effect of X80 Steel by Weak Magnetic Excitation

Enhancing Wire-Rope Damage Signals Based on a Radial Magnetic Concentrator Bridge Circuit

Multi-loop magnetisation method for detecting coal mine wire rope defects

Extraction of weak signal based on wire rope detection in timing belt of wind turbines

Research of The Wire Rope LMA Nondestructive Testing Technology Based on Magnetic Bridge

Structure and Character Analysis of a New Type of Steel Wire Rope NDT Detector Apparatus

Research on magnetoelastic coupling model based on magnetic dipole theory

Novel Diagnostic of Steel Wire Rope With Passive Magnetic Methods

Experimental study on stress detection of corroded steel bars based on piezomagnetic effect

A Steel Wire Stress Measuring Sensor Based on the Static Magnetization by Permanent Magnets

A Review of Wire Rope Detection Methods, Sensors and Signal Processing Techniques

Residual magnetic field as a source of information about steel wire rope technical condition

Theoretical and Experimental Investigation on the Magnetomechanical Effect of Steel Bars Subjected to Cyclic Load