Influence of preparation method of high surface area MnOx/SBA-15 catalysts for the activation of n-octane

Kershen Naicker,Abdul S. Mahomed,Holger B. Friedrich,Sooboo Singh
DOI: https://doi.org/10.1007/s10934-018-0648-6
2018-07-31
Journal of Porous Materials
Abstract:Manganese oxide with varying weight loadings (2, 9 and 18 wt%) were supported on SBA-15 and used to investigate the oxidative dehydrogenation of n-octane. Wet impregnation was used firstly to synthesize catalysts with larger clusters of manganese oxide on the surface of the SBA-15 support. In addition, deposition precipitation was used to prepare catalysts with smaller metal oxide particles in the pores of the SBA-15 support. The corresponding catalytic activity of these two groups of catalysts was then used to assess which method would yield more promising results. There were variances in characterization data between the two groups of catalysts, with changes in particle size and dispersion the most prominent, reflected by particle size measurements shown in transmission electron microscopy. These different particle sizes showed to have diverse catalytic results for the two groups of catalysts. At approximately 8 mol% iso-conversion, dominant product groups obtained were octene isomers and carbon oxides. The catalysts prepared by wet impregnation were found to have the best selectivity towards octene isomers, with the 9 wt% catalyst showing the best results.
materials science, multidisciplinary,chemistry, physical, applied
What problem does this paper attempt to address?