Abstract:The commercial, CO2-intensive, propylene generation process is challenged by a low equilibrium yield, costly separation processes, and severe carbon deposition. Oxidative dehydrogenation (ODH) of propane offers a promising alternative; however, its potential is hampered by the undesirable over-oxidation of propylene to carbon oxides. Chemical looping approaches have been used, where a metal oxide reacts with propane and/or hydrogen – instead of O2 – which can avoid over-oxidation of the hydrocarbons to carbon oxides. Oxygen can then react with the reduced solid product to regenerate it to a stoichiometric oxide. However, solid chemical looping catalysts have a low oxygen carrying capacity, often less than 1 % in order to avoid cyclic deactivation, arising from changes to the lattice structure in each cycle. Herein, we report the use of molten metals as chemical looping catalysts, where the catalyst completely reduces to metallic form and melts each half-cycle. A high oxygen capacity is possible, and melting reduces lattice strain upon reduction. Thermodynamic calculations indicate that 21 individual metal candidates could be viable, and the most promising 14 are experimentally compared. Bi-Sn had the highest conversion, and 50-50 mol% Bi-Sn was supported in a fixed-bed reactor. This resulted in 22 % propylene yield at 600 °C, compared to a 20 % yield from the reference using borosilicate beads at the same temperature. After 10 cycles with separate flows of O2 followed by C3H8, totaling 37 hours on stream, no deactivation was observed. Enhanced propylene selectivity was observed using a 50-50 mol% Bi-Sn molten mixture, surpassing the performance of Bi or Sn alone, and leading to reduced carbon oxide formation. This improved selectivity occurred with both co-fed and pre-oxidized catalysts, suggesting the creation of a unique metal oxide selectively generating propylene while minimizing overoxidation to carbon oxides. Additionally, the oxygen conversion over the Bi-Sn alloy was lower than over Bi or Sn separately when co-feeding propane and oxygen. Selectivity to cracked products was high for most of the active melts tested, especially above 550 °C.

Catalytic Conversion of Biomass-Derived 1,2-Propanediol to Propylene Oxide over Supported Solid-Base Catalysts

Catalytic Dehydration of 2,3-Butanediol over P/Hzsm-5: Effect of Catalyst, Reaction Temperature and Reactant Configuration on Rearrangement Products

Epoxidation of propylene to propylene oxide catalyzed by μ-oxo-bismetalloporphyrins

Epoxidation of propylene to propylene oxide catalyzed by large-grain TS-1 in supercritical CO2

Influence of Acid-Base Properties of ZnMgAl-mixed Oxides for the Synthesis of 1-Methoxy-2-propanol

An atom-economic reaction for synthesis of 1-phenoxy-2-propanol over Al2O3/MgO

Characterization and catalytic performance of supported molybdophosphoric acid catalysts for the oxidation of propylene to acetone

Self-evolved BOx Anchored on Mg2B2O5 Crystallites for High-Performance Oxidative Dehydrogenation of Propane

Design and optimization of a catalytic membrane reactor for the direct synthesis of propylene oxide

A high propylene productivity over B2O3/SiO2@honeycomb cordierite catalyst for oxidative dehydrogenation of propane

Modifier Effect in Silica-Supported FePO4 and Fe-Mo-O Catalysts for Propylene Glycol Oxidation

Propane Oxidative Dehydrogenation Catalyzed by Molten Metal Alloys

Propylene Production via Oxidative Dehydrogenation of Propane with Carbon Dioxide over Composite MxOy-TiO2 Catalysts

Rational design of structured Co3O4@silicalite-1/SiC foam catalyst for microwave-assisted highly efficient conversion of bio-isopropanol to green propylene

Selective Hydrogenolysis of Glycerol to 1,2-Propanediol Catalyzed by Supported Bimetallic PdCu-KF/γ-Al2O3

Application of Co-Al Catalysts in Hydrogenation of Glycidol to 1,3-Propanediol

Catalysts development for O2-assisted oxidative dehydrogenation of propane to propylene

Photothermal catalytic CO2 oxidative dehydrogenation of propane to propylene over BiOX (X = Cl, Br, I) nanocatalysts

Catalytic Transfer Hydrogenolysis of Α-Methylbenzyl Alcohol Using Palladium Catalysts and Formic Acid

Chemical kinetics and promoted Co-immobilization for efficient catalytic carbonylation of ethylene oxide into methyl 3-hydroxypropionate

Concerted oxygen diffusion across heterogeneous oxide interfaces for intensified propane dehydrogenation