Abstract:Vibration-based Structural Health Monitoring (SHM) techniques are among the most common approaches for structural damage identification. The presence of damage in structures may be identified by monitoring the changes in dynamic behavior subject to external loading, and is typically performed by using experimental modal analysis (EMA) or operational modal analysis (OMA). These tools for SHM normally require a limited number of physically attached transducers (e.g. accelerometers) in order to record the response of the structure for further analysis. Signal conditioners, wires, wireless receivers and a data acquisition system (DAQ) are also typical components of traditional sensing systems used in vibration-based SHM. However, instrumentation of lightweight structures with contact sensors such as accelerometers may induce mass-loading effects, and for large-scale structures, the instrumentation is labor intensive and time consuming. Achieving high spatial measurement resolution for a large-scale structure is not always feasible while working with traditional contact sensors, and there is also the potential for a lack of reliability associated with fixed contact sensors in outliving the life-span of the host structure. Among the state-of-the-art non-contact measurements, digital video cameras are able to rapidly collect high-density spatial information from structures remotely. In this paper, the subtle motions from recorded video (i.e. a sequence of images) are extracted by means of Phase-based Motion Estimation (PME) and the extracted information is used to conduct damage identification on a 2.3-m long Skystream® wind turbine blade (WTB). The PME and phased-based motion magnification approach estimates the structural motion from the captured sequence of images for both a baseline and damaged test cases on a wind turbine blade. Operational deflection shapes of the test articles are also quantified and compared for the baseline and damaged states. In addition, having proper lighting while working with high-speed cameras can be an issue, therefore image enhancement and contrast manipulation has also been performed to enhance the raw images. Ultimately, the extracted resonant frequencies and operational deflection shapes are used to detect the presence of damage, demonstrating the feasibility of implementing non-contact video measurements to perform realistic structural damage detection.

Continuous-wave line laser thermography for monitoring of rotating wind turbine blades

Condition Monitoring of Wind Turbine Blades Using Active and Passive Thermography

Damage Detection for Rotating Blades Using Digital Image Correlation with an AC-SURF Matching Algorithm

Induction Infrared Thermography and Thermal-Wave-Radar Analysis for Imaging Inspection and Diagnosis of Blade Composites

Application of a Laser Profile Sensor for the Full-Field Measurement of the Continuous Icing Process of Rotating Blades

Damage detection and full surface characterization of a wind turbine blade using three-dimensional digital image correlation

Damage Mode Identification and Singular Signal Detection of Composite Wind Turbine Blade Using Acoustic Emission

Monitoring fatigue delamination growth in a wind turbine blade using passive thermography and acoustic emission

Thermal Inspection of Subsurface Defects in Wind Turbine Blade Segments under the Natural Solar Condition

Damage Mode Identification of Composite Wind Turbine Blade under Accelerated Fatigue Loads Using Acoustic Emission and Machine Learning

Damage detection in wind turbine blades using embedded radar networks

Damage detection for wind turbine rotor blades using airborne sound

Active vibration-based structural health monitoring system for wind turbine blade: Demonstration on an operating Vestas V27 wind turbine

A new calibration method between an optical sensor and a rotating platform in turbine blade inspection

Deep learning-based fatigue damage segmentation of wind turbine blades under complex dynamic thermal backgrounds

Vibration-based damage detection in wind turbine blades using Phase-based Motion Estimation and motion magnification

In-situ Condition Monitoring of Wind Turbine Blades: A Critical and Systematic Review of Techniques, Challenges, and Futures

An Ultra-Compliant and Flexible Structural Sensing Neural System for Damage Detection in Wind Turbine Blades

Hyperspectral imaging applied for the detection of wind turbine blade damage and icing

A Novel Image-Based Long-Range Continuously Scanning Laser Doppler Vibrometer for Operational Modal Analysis of a Rotating Structure

Non-Contact Wind Turbine Blade Crack Detection Using Laser Doppler Vibrometers