Abstract:The increasing demand for wind power has led to a significant increase in the number and size of wind turbine blades manufactured globally. As the number and physical size of turbines deployed grow, the probability of manufacturing defects being present in composite turbine blades also increases. As capital blade costs and operational and maintenance expenses increase in ever larger turbine systems, the need for inspection of the structural health of large-scale turbine blades during operation critically increases. One method for locating and quantifying manufacturing defects, while also allowing for the in situ measurement of the structural health of blades, is monitoring the full-field deformation and strain of a blade. In a demonstration of this methodology, static tests were performed on a Sandia National Laboratories CX-100 9-m composite turbine blade to extract full-field displacement and strain measurements. Three-dimensional digital image correlation was used. Measurements were taken at previously identified damaged areas near the blade root, along the high- and low-pressure surfaces. The results indicate that the measurement approach can clearly identify failure locations and discontinuities in the blade curvature under load. Postprocessing of the data, using a stitching technique of digital image correlation snapshots taken along the length of the blade, allows observation of the shape and curvature of the entire blade. The experiment demonstrates the feasibility of the approach and reveals that the technique can be readily scaled to accommodate utility-scale blades. As long as a trackable pattern is applied to the surface of the blade, measurements can be made in situ when a blade is on a manufacturing floor, installed in a test fixture, or installed on a rotating turbine. The results demonstrate the potential of the optical measurement technique for use in the wind industry.

Thermal Inspection of Subsurface Defects in Wind Turbine Blade Segments under the Natural Solar Condition

Condition Monitoring of Wind Turbine Blades Using Active and Passive Thermography

UAV based defect detection and fault diagnosis for static and rotating wind turbine blade: a review

Dynamic Characteristics Monitoring of Large Wind Turbine Blades Based on Target-Free DSST Vision Algorithm and UAV

Research on Infrared Thermal Wave Non-destructive Inspection Technology of Turbine Blades

Monitoring fatigue delamination growth in a wind turbine blade using passive thermography and acoustic emission

Research on infrared nondestructive testing and thermal effect analysis of small wind turbine blades under natural excitation

Induction Infrared Thermography and Thermal-Wave-Radar Analysis for Imaging Inspection and Diagnosis of Blade Composites

Developing Inspection Methodology of Solar Energy Plants by Thermal Infrared Sensor on Board Unmanned Aerial Vehicles

Hyperspectral imaging applied for the detection of wind turbine blade damage and icing

Study on Air Bubble Defect Evolution in Wind Turbine Blade by Infrared Imaging with Rheological Theory

Damage Mode Identification of Composite Wind Turbine Blade under Accelerated Fatigue Loads Using Acoustic Emission and Machine Learning

Using Drones for Thermal Imaging Photography and Building 3D Images to Analyze the Defects of Solar Modules

Damage Mode Identification and Singular Signal Detection of Composite Wind Turbine Blade Using Acoustic Emission

Towards Operating Wind Turbine Inspections using a LiDAR-equipped UAV

Damage detection and full surface characterization of a wind turbine blade using three-dimensional digital image correlation

Continuous-wave line laser thermography for monitoring of rotating wind turbine blades

Unmanned Aerial Vehicle (UAV)-Assisted Damage Detection of Wind Turbine Blades: A Review

3D Detection of Internal Defects for Gas Turbine Blades

Research on the Defect Types Judgment in Wind Turbine Blades Using Ultrasonic NDT

Automated detection-classification of defects on photo-voltaic modules assisted by thermal drone inspection