Abstract:Carbon fiber reinforced polymer (CFRP) composites with remarkable mechanical properties are widely used in aerospace crafts as load-bearing components. However, harsh environmental conditions challenge the security design of lightweight composite structures. In this work, the effects of cryogenic temperature from 77 K to 298 K and cryogenic stability after 50, 100 and 150 cycles on the mechanical properties and failure modes of CFRP laminates with various stacking sequences were experimentally investigated. In-situ static tensile and three-point bending tests were conducted. A progressive damage model was developed based on three-dimensional (3D) Hashin criterion. Unique insights into the internal microdefect and damage evolution of laminates after 150 thermocycling were obtained by X-ray computed tomography (X-ray CT) technique. The results revealed significant degradation in tensile strength and modulus of laminates with the decrease in temperature due to changes in failure mode. The flexural properties improved by over 50% thanks to shrinkage in chemical bonding between matrix molecules. The influence of thermocycling on the mechanical properties was shown insignificant (0.2%-13%) under slow cooling rates. The degradation in properties of quasi-isotropy laminates looked more significant than that of unidirectional due to the coupling effect of thermal expanding mismatch between material (fiber and matrix) and layer. Quasi-isotropy laminated exhibited significantly greater microcrack volume fractions (more than 6-fold after 150 cycles). As thermocycling rose, the microcracks gradually expanded and nucleation occurred within the interfacial layer. The results here provide a way for the structure design of cryogenic composite tanks under complex working environments by studying the temperature effect.

Effect of the cooling rate on the fracture toughness of carbon fiber reinforced thermoplastic composites

The effect of cooling rate on crystallization behavior and tensile properties of CF/PEEK composites

The effect of cooling rates on crystallization and low-velocity impact behaviour of carbon fibre reinforced poly(aryl ether ketone) composites

Effects of Cooling Rate on the Crystallinity and Mechanical Properties of Thermoplastic Composites

Elucidation of crystalline morphology, crystallinity and mechanical properties of carbon fibre/PEEK composites under different cooling rates

Cooling rate-dependent mechanical properties of polyphenylene sulfide (PPS) and carbon fiber reinforced PPS (CF/PPS)

Mode I Fracture Toughness with Fiber Bridging of Unidirectional Composite Laminates under Cryogenic Temperature

Inherent relationship between process parameters, crystallization and mechanical properties of continuous carbon fiber reinforced peek composites

Inverse Effects of Cooling Rates on the Interfacial Shear Strength of Carbon Fiber/PEEK Composites with and without Presence of Transcrystal Layers

The influence of temperature and moisture on the mode I fracture toughness and associated fracture morphology of a highly toughened aerospace CFRP

Influence of cooling rate on the properties of carbon fiber unidirectional composites with polypropylene, polyamide 6, and polyphenylene sulfide matrices

The Optimization of Thermo-Compression Process Parameters of Continuous Carbon Fiber Reinforced PEEK Composites

Effect of cooling rate on microstructure and properties of SiC P /A359 composites

Evaluation of the Fracture Toughness of Short Carbon Fiber Reinforced Thermoplastic Composites

The Effect of Cooling Rate on Resistance-Welded CF/PEEK Joints

Effect of Cooling Rate on Microstructure and Properties of SiCP/A359 Composites

Improving Interlaminar Fracture Toughness and Impact Performance of Carbon Fiber/Epoxy Laminated Composite by Using Thermoplastic Fibers

Mechanical Properties and Internal Microdefects Evolution of Carbon Fiber Reinforced Polymer Composites: Cryogenic Temperature and Thermocycling Effects

STUDY ON COOLING RATE-DEPENDENT MECHANICAL PROPERTIES OF THERMOPLASTIC COMPOSITES

Effect of the cooling rate on the mechanical properties of glass fiber reinforced thermoplastic composites