Electron microprobe technique for the determination of iron oxidation state in silicate glasses

Chao Zhang,Renat R. Almeev,Ery C. Hughes,Alexander A. Borisov,Eric P. Wolff,Heidi E. Höfer,Roman E. Botcharnikov,Jürgen Koepke

DOI: https://doi.org/10.2138/am-2018-6437

IF: 3.066

2018-09-01

American Mineralogist

Abstract:We present a new calibration for the determination of the iron oxidation state in silicate glasses by electron probe microanalysis (EPMA) with the “flank method.” This method is based on the changes in both intensity and wavelength of the FeLα and FeLβ X-ray emission lines with iron oxidation state. The flank method utilizes the maximum difference for the FeLα and FeLβ spectra observed at the peak flanks between different standard materials, which quantitatively correlates with the Fe2+ content. Provided that this correlation is calibrated on reference materials, the Fe2+/ΣFe ratio can be determined for samples with known total Fe content. Two synthetic Fe-rich ferric and ferrous garnet end-members, i.e., andradite and almandine, were used to identify the FeLα and FeLβ flank method measuring positions that were then applied to the measurement of a variety of silicate glasses with known Fe2+/ΣFe ratio (ranging from 0.2 to 1.0). The measured intensity ratio of FeLβ over FeLα at these flank positions (Lβ/Lα) is a linear function of the Fe2+content (in wt%). A single linear trend can be established for both garnets and silicate glasses with 4–18 wt% FeOT (total iron expressed as FeO). In glasses with up to 18 wt% FeOT and 15 wt% TiO2, no systematic compositional (matrix) effects were observed. A possible influence of Ti on the Fe2+ determination has only been observed in one high-Ti glass with ~25 wt% TiO2, a content that is not typical for natural terrestrial silicate melts. The accuracy of the Fe2+/ΣFe determination, which depends on both the Fe2+ content determined with the flank method and on the total Fe content, is estimated to be within ±0.1 for silicate glasses with FeOT > 5 wt% and within ±0.3 for silicate glasses with low FeOT ≤ 5 wt%. The application of the flank method on silicate glasses requires minimization of the EPMA beam damage that can be successfully achieved by continuous movement of the sample stage under the electron beam during analysis, e.g., with a speed of 2 μm/s.

geochemistry & geophysics,mineralogy