Abstract:AbstractThe detailed modeling of temperature and friction for coiled tubing (CT) operations is especially important in extended-reach wells. Although the fluid flow through the CT and annulus, downhole temperature, and the CT mechanical friction inside the well are crucial during CT operations, a mathematical model that captures all these effects does not currently exist.In a separate study, we propose a new temperature-dependent coefficient of friction correlation, based on an extensive in-house experimental data set. In the current study we implement this correlation in a thermal well flow model. The model includes transient single-phase mass, momentum, and energy balance equations for the CT and annulus. Heat exchange between tubing and annulus and between annulus and formation as well as heat generated by CT mechanical friction while sliding inside the well are included in the model. Frictional pressure drops due to the fluid flowing downwards through the tubing and upwards through the annulus are also included in the momentum equations. The formation temperature is assumed to be geothermal. Although the model is aimed specifically at CT operations, it can easily be extended to other applications where thermal multiphase well flow in tubing and annulus is important.We proceed by first presenting two analytical solutions for tubing and annulus temperature under various assumptions (similar solutions have been previously obtained for drilling operations). We then describe the use of one of these solutions, which allows for space-dependent fluid density and velocity and time- and space-dependent temperature inside the tubing and the annulus. The analytical model is verified against the corresponding numerical model that solves the full mass, momentum, and energy conservation equations and is validated against a Distributed Temperature Sensing (DTS) field case. Close agreement is obtained for the cases presented. A synthetic case that shows the effect of several key downhole parameters on tubular and annular temperature is also presented. We show that temperature distribution inside the well is important for best prediction of an average coefficient of friction for the entire well. For instance, the generic coefficient of friction of 0.24 that is currently used in the planning of CT operations does not apply for similar CT strings in wells with different downhole temperatures. The overall procedure is therefore very well suited for use in thermal simulation of CT operations.

Wellbore temperature and pressure calculation model for coiled tubing drilling with supercritical carbon dioxide

Numerical investigation on wellbore temperature and pressure during carbon dioxide fracturing

Numerical investigation of wellbore temperature and pressure fields in CO2 fracturing

Pressure Model and Calculation of Well Test for Gas Wells with CO2 Injection Considering Thermal Effect

NUMERICAL INVESTIGATION OF KEY PARAMETER EFFECTS ON TEMPERATURE AND PRESSURE IN WELLBORE DURING CARBON DIOXIDE FRACTURING

Research on Wellbore Integrity Evaluation Model of CO2 Enhanced Composite Fracturing

Thermal Modelling In And Around A Co2 Injector

Simulation of wellbore temperature and pressure field in supercritical carbon dioxide fracturing

A Thermal-Fluid-Solid Coupling Computation Model of Initiation Pressure Using Supercritical Carbon Dioxide Fracturing

Phase state variations for supercritical carbon dioxide drilling

Flow and Thermal Modeling of CO2 in Injection Well During Geological Sequestration

Estimation and Analysis of Carbon Dioxide Friction Loss in Wellbore During Liquid/Supercritical Carbon Dioxide Fracturing

A prediction model of wellbore temperature and pressure distribution in hydrocarbon gas injection well

The Influence of CO2 Physical Properties on Casing and Its Prediction Method

Analytical Downhole Temperature Model for Coiled Tubing Operations

Study on wellbore fluid flow and heat transfer of a multilateral-well CO2 enhanced geothermal system

Phase State Control Model of Supercritical CO2 Fracturing by Temperature Control

Study on the wellbore temperature distribution characteristics during foam drilling

Research on Temperature–Pressure Coupling Model of Gas Storage Well during Injection Production

The Sensitivity Analysis of Wellbore Heat Transfer During the Co2 Injection Process

The Sensitivity Analysis of Wellbore Heat Transfer during the CO<sub>2</sub> Injection Process