Abstract:Quaternary Ni-rich layered cathodes are one of the most intriguing yet challenging next-generation cathode materials, and their high Ni content has made it difficult to obtain long-term cyclability. In this paper, we report the improved electrochemical performance of high-power long-life Ni-rich layered cathode materials (LiNi0.90Co0.04Mn0.03Al0.03O2, denoted NCMA), synthesized in a Couette–Taylor reactor, after depositing a homogeneous surface coating of Li2ZrO3 (LZO). Morphological analyses revealed that the thickness of the LZO coating was approximately 2.5 nm and spread uniformly on the NCMA surface. X-ray photoelectron spectroscopy indicated that the content of Li residues on the surface had greatly decreased after coating with LZO. The electrochemical performance of the coated samples was greater than that of the bare NCMA; in particular, the 1 wt % LZO-coated cathode material had a capacity retention of 90.2% after 100 cycles at 1C (vs 74.6% for the bare NCMA). Electrochemical impedance spectroscopy (EIS), cyclic voltammetry (CV), and the galvanostatic intermittent titration technique (GITT) indicated that the coating agent acted as a bridge that lowered the activation energy and polarization potential for a better Li+ ion transport. The polarization potential also decreased significantly after coating with LZO, leading to improved electrochemical kinetics. Postmortem studies after long cycling confirmed that the LZO coating layer enhanced the structural stability of the cathode.The Supporting Information is available free of charge at https://pubs.acs.org/doi/10.1021/acsaem.2c00224.Details on the schematic diagram representing the synthesis method of NCMA hydroxides and oxides, XRD patterns of bare NCMA and 5 wt % LZO-coated NCMA, peaks that correspond to LZO, XPS spectra of Co 2p, Mn 2p, and wide scan spectra of bare and 1 wt % LZO-coated NCMA cathodes, high-rate discharge plots (0.2–10C) of bare and LZO-coated NCMA cathodes, and long cycle testing of all the prepared cathodes at 1C for 100 cycles in 2.8–4.5 V (PDF)This article has not yet been cited by other publications.

Quaternary Layered Ni-Rich NCMA Cathode for Lithium-Ion Batteries

Radially Oriented Single‐Crystal Primary Nanosheets Enable Ultrahigh Rate and Cycling Properties of LiNi0.8Co0.1Mn0.1O2 Cathode Material for Lithium‐Ion Batteries

Al- and Nb-Comodified Ni-Rich NCM Cathode for High-Performance Lithium-Ion Batteries

Synthesis of Single Crystal LiNi 0.92 Co 0.06 Mn 0.01 Al 0.01 O 2 Cathode Materials with Superior Electrochemical Performance for Lithium Ion Batteries

Microstructure Engineered Ni‐Rich Layered Cathode for Electric Vehicle Batteries

Synthesis of Single Crystal LiNi0.92Co0.06Mn0.01Al0.01O2 Cathode Materials with Superior Electrochemical Performance for Lithium Ion Batteries

Advancing Lithium-Ion Batteries' Electrochemical Performance: Ultrathin Alumina Coating on Li(Ni0.8Co0.1Mn0.1)O2 Cathode Materials

Surface-Modified Quaternary Layered Ni-Rich Cathode Materials by Li 2 ZrO 3 for Improved Electrochemical Performance for High-Power Li-Ion Batteries

Aluminum and Indium Co‐Modified Ni‐Rich Layered Cathode with Enhanced Microstructure and Surface Stability for Lithium‐Ion Batteries

High structure stability and Li-conduction of LiNi0.8Co0.1Mn0.1O2 cathode co-coated by Al2O3 and LiNbO3 for high performance lithium-ion battery

Enhancing Structural Rigidity of Ultrahigh‐Ni Oxide Through Al and Nb Dual‐Bulk‐Doping for High‐Voltage Lithium‐Ion Batteries

Enhanced lithium storage capability of Ni-rich LiNi0.9CoxMn0.1−xO2(0 ≤ x ≤ 0.1) cathode by co-operation of Al-doping and V-coating

Towards the high-energy-density battery with broader temperature adaptability: Self-discharge mitigation of quaternary nickel-rich cathode

Boosting Cell Performance of LiNi 0.8 Co 0.15 Al 0.05 O 2 via Surface Structure Design.

In Situsynthesis Of A Nickel Concentration Gradient Structure Of Ni-Rich Lini(0.8)Co(0.15)Al(0.05)O(2)With Promising Superior Electrochemical Properties At High Cut-Off Voltage

Improved rate and cyclic performance of potassium-doped nickel-rich ternary cathode material for lithium-ion batteries

In situ synthesis of a nickel concentration gradient structure of Ni-rich LiNi0.8Co0.15Al0.05O2 with promising superior electrochemical properties at high cut-off voltage

Advantageous Surface Engineering to Boost Single-Crystal Quaternary Cathodes for High-Energy-Density Lithium-Ion Batteries

Residual Alkali-Evoked Cross-Linked Polymer Layer for Anti-Air-sensitivity LiNi0.89Co0.06Mn0.05O2 Cathode

Tuning Dopant Distribution for Stabilizing the Surface of High‐Nickel Layered Oxide Cathodes for Lithium‐Ion Batteries

Protective and ion conductive: High-Rate Ni-Rich cathode with enhanced cyclic stability via One-Step bifunctional dual-layer coating