Abstract:In the current study, the low carbon Ni-based superalloy Inconel-738 (IN-738LC) was used as the substrate and a metallic bond coat (NiCrAlY) was deposited on the substrate by air plasma spray (APS) method. Subsequently, the layer was coated by a ceramic interlayer Yttria-stabilized zirconia (YSZ) by APS. Finally, as the last ceramic layer, a hybrid ceramic top layer containing mullite and YSZ was plasma deposited on the YSZ interlayer in various compositions such as: 25 wt% mullite/75 wt% YSZ, 50 wt% mullite/50 wt% YSZ, 75 wt% mullite/25 wt% YSZ, and 100 wt% mullite. In order to investigate the oxidation resistance of the produced TBCs, they were heated at 1000 °C for 50 and 100 h. The results showed that the presence of mullite phase is advantageous to hybrid coatings, so that in the 50 wt% mullite/50 wt% YSZ hybrid coating, the percentage of destructive spinel oxides forming the thermally grown oxide (TGO) layer reduced compared to the 25 wt% mullite/75 wt% YSZ coating. Moreover, aluminum oxide is the dominant oxide in the 50 wt% mullite/50 wt% YSZ hybrid coating. However, the further increase in the mullite percentage had no noticeable effect on the reduction of spinel oxides. In addition, the presence of mullite alongside YSZ led to an increase in the hardness of the 25 wt% mullite/75 wt% YSZ hybrid coating (845 HV) compared to the conventional coating including a YSZ layer (680 HV) or a mullite layer (655 HV). The X-ray diffraction (XRD) analysis revealed that the presence of mullite beside YSZ in the coating increases the stability of the coating after oxidation test so that, in the XRD pattern, monoclinic phase was not detected in the hybrid coatings. In general, 50 wt% mullite/50 wt% YSZ hybrid coating provided the best results compared to other coatings. Moreover, with increasing thickness of the hybrid ceramic layer containing 50 wt% mullite to 350 μm, the thickness of the TGO layer decreased to approximately 7 μm. Additionally, it was shown that due to the decrease of chromium and nickel elements in the TGO layer, the level of the spinel oxides in the thick coatings decreases. This led to an increase in the stability of the TGO layer and an extension of the thermal system's lifespan.

Pack cemented silicon carbide interlayer for plasma sprayed yttria over graphite

Passive Filler-Loaded Silicon Oxycarbide Coating on Nickle Alloy with High Thermal Shocking Behavior and Oxidation Resistance

Thermal durability of ytterbium silicate environmental barrier coating prepared by suspension plasma spray

Influence of Yttria content in YSZ: An evaluation of water-based SPS coatings and spark plasma sintered pellets

Oxidation resistance and thermal shock behavior of tri-layer Si/Si–Yb2SiO5/Yb2SiO5–SiC environmental barrier coatings at 1300 °C

Thermal cycling behavior of La2Zr2O7/Yb2Si2O7/SiC coated PIP Cf/SiC composites under burner rig tests

Microstructural evolution and high-temperature oxidation behavior of plasma sprayed SiC-YSZ TBCs

Ytterbium Disilicate/Monosilicate Multilayer Environmental Barrier Coatings: Influence of Atmospheric Plasma Spray Parameters on Composition and Microstructure

Isothermal Oxidation and Thermal Shock Resistance of Thick and Porous LaMgAl11O19 Abradable Topcoat

Mullite/YSZ hybrid thermal barrier coatings plasma sprayed on IN-738LC: Microstructure, phase analysis and oxidation resistance

Preparation of SiC Composite Coating on the Surface of Graphite Spheres in VHTR

Thermal shock resistance and bonding strength of tri-layer Yb2SiO5/mullite/Si coating on SiCf/SiC composites

Thermophysical properties and cyclic lifetime of plasma sprayed SrAl 12 O 19 for thermal barrier coating applications

Multilayer GZ/YSZ Thermal Barrier Coating from Suspension and Solution Precursor Plasma Spray

Assessment of the Performance of Y2SiO5-YSZ/YSZ Double-Layered Thermal Barrier Coatings

Rear Earth Oxide Multilayer Deposited by Plasma Spray-Physical Vapor Deposition for Envisaged Application as Thermal/Environmental Barrier Coating

Micro Four‐Layer SiC Coating on Matrix Graphite Spheres of HTR Fuel Elements by Two‐Step Pack Cementation

Pack Deposition Of Oxidation Resistant Silicide And Aluminide Coatings On Gamma-Tial

Thermal shock behavior and oxidation resistance of novel SiC nanowires+Si/Yb2Si2O7-Si/Yb2Si2O7 environmental barrier coatings

Microstructures and Phases of Ytterbium Silicate Coatings Prepared by Plasma Spray-Physical Vapor Deposition

Corrosion behavior and failure mechanism of SiC whisker and c-AlPO4 particle-modified novel tri-layer Yb2Si2O7/mullite/SiC coating in burner rig tests