Fabrication of Matrix Graphite with a High Degree of Graphitization for Spherical Fuel Elements by Using Natural Microcrystalline Graphite Fillers
Xinlei Cao,Shen Lv,Kun Xu,Xiaohui Wang,Jingxu Wang,Bing Liu,Ke Shen
DOI: https://doi.org/10.1016/j.net.2024.06.049
IF: 2.817
2024-01-01
Nuclear Engineering and Technology
Abstract:Matrix graphite is used as a structural material, thermal conductor, moderator, and secondary fission product barrier for fuel elements in high-temperature gas-cooled reactors (HTRs). Due to its high graphitization degree and compressibility, natural flake graphite (NFG) is used as the main filler in traditional A3-3 matrix graphite, whereas artificial graphite (AG), with a lower graphitization degree than NFG, serves as an additive for toughness and gas permeability. Matrix graphite could be improved in terms of thermal conductivity, oxidation resistance, and irradiation performance by increasing the degree of graphitization. However, reports on the development of new matrix graphite formulations are scarce. In this study, MG-20 matrix graphite was prepared by mixing 60 wt % NFG, 20 wt% natural microcrystalline graphite (MG), and 20 wt% phenolic resin. Due to the high graphitization degree (higher than AG) and low coefficient of thermal expansion (CTE) of MG, MG-20 exhibited higher thermal conductivity (similar to 6%) and lower CTE (similar to 2.4%) than A3-3. Thus, MG-20 with higher graphitization degree and better thermal properties than A3-3 could improve the performance of HTR fuel elements in the future.