Abstract:The calibration method using a high-power halogen tungsten lamp as a calibration source has many advantages such as strong equivalence and high power, so it is very fit for the calibration of high-energy laser energy meters. However, high-power halogen tungsten lamps after power-off still reserve much residual energy and continually radiate energy, which is difficult to be measured. Two measuring systems were found to solve the problems. One system is composed of an integrating sphere and two optical spectrometers, which can accurately characterize the radiative spectra and power-time variation of the halogen tungsten lamp. This measuring system was then calibrated using a normal halogen tungsten lamp made of the same material as the high-power halogen tungsten lamp. In this way, the radiation efficiency of the halogen tungsten lamp after power-off can be quantitatively measured. In the other measuring system, a wide-spectrum power meter was installed far away from the halogen tungsten lamp; thus, the lamp can be regarded as a point light source. The radiation efficiency of residual energy from the halogen tungsten lamp was computed on the basis of geometrical relations. The results show that the halogen tungsten lamp's radiation efficiency was improved with power-on time but did not change under constant power-on time/energy. All the tested halogen tungsten lamps reached 89.3% of radiation efficiency at 50 s after power-on. After power-off, the residual energy in the halogen tungsten lamp gradually dropped to less than 10% of the initial radiation power, and the radiation efficiency changed with time. The final total radiation energy was decided by the halogen tungsten lamp's radiation efficiency, the radiation efficiency of residual energy, and the total power consumption. The measuring uncertainty of total radiation energy was 2.4% (here, the confidence factor is two). (c) 2015 Optical Society of America

Performances of different efficiency calibration methods of high-purity-germanium gamma-ray spectrometry in an inter-comparison exercise

A gamma ray sourceless efficiency calibration method based on the Boolean operation of the ray deposition process

Calibration of High Dose Field in 60 Co-γ Irradiation Equipment

Calibrate the Non-Orthogonal Error of AFM with Two-Dimensional Self-Traceable Grating.

Efficiency Calibration of Neutron Detectors with Large Area

Design of simulated-gas calibration source and self-attenuation correction methods for radioactive noble gas measurement with HPGe detector

The Efficiency Calibration of Radioxenon Isotopes of Inhomogeneous Adsorption Column for HPGe Γ Spectrometry

A simple approach to determine the radioactivities of nuclides with 200–2000 keV γ ray(s) in the absence of efficiency calibration standard

Efficiency calibration and self-attenuation correction in radioxenon measurement using β-γ coincidence method

Electro-optical Equivalent Calibration Technology for High-Energy Laser Energy Meters

The full-energy peak efficiency of gamma-ray spectrometry by numerical calculation method

Monte Carlo based absolute efficiency calibration of power reactor spent fuel NDA measurements

Efficiency Calibration of a Large-Area Neutron Detector by Using Am/Be Neutron Source

MONTE CARLO CALCULATION AND COMPARISON OF GAMMA/NEUTRON DISCRIMINABILITY OF SOME SCINTILLATORS

Intrinsic Efficiency Calibration Considering Geometric Factors in Gamma-Ray Computed Tomography for Radioactive Waste Assay

Technology for radiation efficiency measurement of high-power halogen tungsten lamp used in calibration of high-energy laser energy meter.

Detection Efficiency Calculations Using Geant4 for a Broad-Energy Germanium Gamma Spectrometer

Performance comparison of four common LINAC daily QA instruments

A Method to Calibrate the N-Γ Discrimination Property of Scintillators in Low Energy Region

Simplified efficiency calibration methods for semiconductor detectors used in criticality dosimetry

A Performance Comparison of Two Kinds of Liquid Scintillation Counters from PerkinElmer, Inc.