Abstract:Fine particles being captured or escaping from particle beds (microchannel separator) is a widespread phenomenon, with the size and distribution of pores (microchannel) significantly affecting these phenomena. However, due to the complexity of the pore structure, accurately measuring and validating it poses challenges. This paper introduces a new method to calculate the critical pore diameter of homogeneous microchannel separators (three types of homogeneous separation media with particle sizes of 0.8 mm, 1.0 mm and 1.2 mm). Initially, particle bed units with a thickness twice the diameter of the separation media were captured from multiple orthogonal projection directions to obtain high-resolution images of the pore structure. Then, the Feret diameter distribution of the pores were analyzed to quantify pore size and distribution. Next, unresolved CFD-DEM method was used to simulate the capture of fine particles to optimize and supplement the results. The results show that the average Feret diameter of the pores differs by only 0.85 μm, 1.70 μm, and 2.46 μm from the simulation results, and it is noted that the critical pore diameter is approximately 0.153 times that of the separation media diameter, the numerical difference from the critical dimension ratio is only 0.0017. Additionally, when the diameter of the fine particles is 0.155 to 0.165 times the diameter of the separation media, the homogeneous microchannel separator exhibits the highest efficiency during the deep bed filtration process. The study also examines the separation of homogeneous fine particles at varying inlet liquid flow rates, which can offer theoretical guidance for analyzing the porosity of microchannel separators and the efficient removal of solid pollutants, thus contributing novel ideas to deep bed filtration research.

CFD-DEM Study of Bridging Mechanism of Particles in Ceramic Membrane Pores under Surface Filtration Conditions

Hydrodynamics and effect of velocity on particle filtration due to bridging in water-saturated porous media using CFD-DEM simulation

Mechanics of the Penetration and Filtration of Cement-Based Grout in Porous Media: New Insights from CFD–DEM Simulations

Effect of Adhesion on Clogging of Microparticles in Fiber Filtration by DEM-CFD Simulation

Study of the Water Cleaning Process by Using CFD-DEM Method: A Case Study of Coarse Filter Material

Particle shape and clogging in fluid-driven flow: A coupled CFD-DEM study

On the morphology and pressure-filtration characteristics of filter cake formation: Insight from coupled CFD-DEM simulations

A Coupled CFD-DEM Model for Resolved Simulation of Filter Cake Formation during Solid-Liquid Separation

Filtration of Micro-Particles Within Multi-Fiber Arrays by Adhesive DEM-CFD Simulation

Effect of Interparticle Dipolar Interaction on Pore Clogging During Microfiltration

Clogging effect of fines in seepage erosion by using CFD–DEM

A Method for Measuring the Critical Pore Diameter of a Homogeneous Microchannel Separator Based on Image Analysis and a Simulation Comparison of CFD-DEM

Pore characteristics of cake by filtration based on LBM-DEM-DLVO coupling method

Particulate Transport in Porous Media at Pore-Scale. Part 1: Unresolved-Resolved Four-Way Coupling CFD-DEM

Analysis of filtration process of 3-D mesh spacer filter by using CFD-DEM simulation

Slurry filtration process and filter cake formation during shield tunnelling: Insight from coupled CFD-DEM simulations of slurry filtration column test

An unresolved CFD-DEM method for studying migration and clogging of fine particles through a packed bed

Mechanisms of Pore-Clogging Using a High-Resolution CFD-DEM Colloid Transport Model

Design and optimization of ceramic membrane structure: From the perspective of flux matching between support and membrane

Dynamic pore modulation of contracted carbon fiber filter for wastewater treatment: Filtration performance and in-situ regeneration mechanism

Impermeable and mechanical stability of filter cake under different infiltration conditions via CFD-DEM