Abstract:The use of slip-critical connections is very common in the design of critical steel structures and is seen as an effective way to transfer the force in conditions of dynamic loading. The limit state of the connection occurs when the calculated shear stress is reached, which depends on the friction coefficient of the contact planes and the value of the clamping force, equal to the bolt tension stress. In order to ensure the necessary bolt tensioning force, it is necessary to know the bolt tightening coefficient, because according to the current understanding of the slip-critical connection performance, the designed functioning of the bolt connection is ensured when the bolt tensioning force arising at the necessary torque value is achieved. Otherwise, the actual work of the connection will be different from the calculated, because only a given tension force provides the estimated bearing capacity of the bolted connection with friction planes. This article focuses on tensile testing of a bolt and determining the tightening factor of a bolt made of high-strength10.9 M14 steel. The tightening factor is determined with strain gauges by measuring the relative strain of the bolt when the nut is tightened. This method requires specialized equipment and a test bench and can be used in the study of bolt performance in the absence of a certificate or the need to verify or clarify the available data. The results show that the proposed method can provide a stable determination of the coefficient value. The examined bolts were made according to the German standard DIN931, strength 10.9 size M14x220, nuts according to the German standard DIN934, strength 10 size M14. An Instron 1000HDX tensile testing machine was used to plot the performance of the bolt steel. Nut tension control was determined with the use of NOGRAU NTW24-034R torque wrench, and bolt elongation control with FLA 5-11 strain gauges and National Instruments data acquisition system. On the basis of the conducted research, a method for determining the tightening factor of high-strength bolts has been tested and proposed. The proposed method of determining the tightening factor of a high-strength bolt can be used in research work and allows to determine the coefficient in the absence of an appropriate certificate or the need to clarify (verify) the stated value of the coefficient.

INFLUENCE OF BOLT TIGHTENING FORCE ON SLIP COEFFICIENT OF HIGH-STRENGTH BOLTED FRICTION TYPE JOINTS

Test on shear behavior of less-tightened high-strength bolted connections

Mechanical Behavior of Loose High-Strength Bolted Connections with Thin Sheet Steels

Fundamental Study for Slip Resistance Improvement of High-Strength Bolted Joints Subjected to Shear and Tension

Experimental investigation of mechanical behavior of grade 8.8 and 10.9 small-sized (m14-m20) bolts with the thread into the bolt hole

Effect of Interference Fit Size on Local Stress in Single Lap Bolted Joints

Experimental determination of the tightening coefficient of bolts according to the din standard

Effects of Different Friction Coefficients on Input Torque Distribution in the Bolt Tightening Process Based on the Energy Method

Experimental Research on Slip Factor in Bolted Connection with Stainless Steel

A New Tightening Method for Bolted Joints by the Simultaneous Application of Torque and Compressive Force

Distribution of the friction coefficient in the tension connections by the HV set using the combined method

Influence of Bolt Quality and Pitch on Shear Behaviors of High-strength Bolt Friction Connection

Changing behavior of friction coefficient for high strength bolts during repeated tightening

The Tightening and Untightening Modeling and Simulation of Bolted Joints

Finite element analysis of bolted joints under torsional loads

Critical load determination for preventing rotational loosening in bolted joints under dynamic transverse loads

Finite Element Analysis on the Bearing Capacity for Connection of Sharing on a Shear Load by Friction-Type High-Strength Bolts and Side Welds

Analyses of Tightening Characteristics and Cyclic Stress Amplitude of Studs and Tap Bolts

SLIP COEFFICIENT OF BOLTED JOINT IN METAL WORK AND ITS APPLICATIONS

The Influence of Friction Coefficient on Bolt Looseness under Low Frequency Vibration Via Finite Element Analysis

Degradation and failure analysis of bolted joints under transverse loading