Abstract:As power efficiency becomes essential in automotive applications, DC-DC converters are widely employed [1]. However, size and thermal limits have made it challenging to continue using standard CMOS-based converters. Gallium Nitride (GaN) FETs, on the other hand, have a much higher conductivity with small size/capacitance in comparison to silicon FETs, enabling a highly efficient power conversion at high switching frequency (f SW ). However, there are several issues that must be resolved before using GaN in automotive. High f SW incurs larger di/dt and dv/dt transitions which injects high frequency electromagnetic interference (EMI) noise into the input bus. This creates unwanted noise or even a malfunction in a safety-critical system. A bulky input filter can reduce EMI, but it greatly increases size and cost. Several techniques [2-5] are reported to mitigate EMI. Frequency hopping using discrete frequencies is proposed in [2], but cannot spread the frequency evenly to lower the peak noise effectively. Alternatively, a series resistor is typically added at the gate of the GaN FET to slow down the transition [3-4]. However, the switching loss is dramatically increased. To mitigate this, adjustable driving strength is proposed in [5]. Unfortunately, the sensing and driver delays confine its use in low f SW applications, where the switch node rising time is several tens or hundreds of ns. Another issue of high f SW operation is that it causes significant current and voltage spikes due to the parasitics at the drain/source of the high side GaN FET (M H ), which could lead to GaN VDS breakdown or damage on logic-level FETs. Thus, EMI noise suppression and reliable operation of GaN FETs remain as major challenges in realizing high f SW power converters for automotive-use.

Implementation of FOC algorithm using FPGA for GaN-based three phase induction motor drive

A Digital PWM Controller of MHz Active Clamp Flyback with GaN Devices for AC-DC Adapter.

25.2 A 10mhz 3-to-40v VIN Tri-Slope Gate Driving GaN DC-DC Converter with 40.5dbµv Spurious Noise Compression and 79.3% Ringing Suppression for Automotive Applications

Vector control implementation in field programmable gate array for 200 kHz GaN-based motor drive systems

Rotor Field Oriented Control Strategy with Harmonic Currents Closed-Loop Control for Five-Phase Induction Motor

Application of FPGA in High-Power Multiphase Variable Speed Drives

Design of LED Production Equipment Molding Motion Controller Base on FPGA

Field-Oriented Control of Five-Phase Induction Motor Fed From Space Vector Modulated Matrix Converter

FPGA Implementation of AI-Based Inverter IGBT Open Circuit Fault Diagnosis of Induction Motor Drives

FPGA‐based real‐time implementation of a direct torque control with second‐order sliding mode control and input–output feedback linearisation for an induction motor drive

Development of an FPGA-based sub-module as three-phase spindle motor speed controller for CNC PCB milling machine

Implementation of Indirect Field Oriented Control Using Space Vector Pulse Width Modulation for the Control of Induction Motor

Variable Frequency Driver System of Asynchronous Motor Based on FPGA

Multi-axis Current Loop Control Based on FPGA

A field-oriented control (FOC) method using the virtual currents for the induction motor drive

FPGA Implementation for Rapid Prototyping of High Performance Voltage Source Inverters

Rapid Prototyping and Hardware-In-the-Loop Verification of Enhanced Sliding Mode Control of an Asynchronous Machine Using a Xilinx System Generator and an FPGA-Zynq Board

FPGAs in Industrial Control Applications

Comparative Evaluation of Three-Phase Three-Level Flying Capacitor and Stacked Polyphase Bridge GaN Inverter Systems for Integrated Motor Drives

Noble Implementation of Motor Driver with All Programmable SoC for Humanoid Robot or Industrial Device