Abstract:As power efficiency becomes essential in automotive applications, DC-DC converters are widely employed [1]. However, size and thermal limits have made it challenging to continue using standard CMOS-based converters. Gallium Nitride (GaN) FETs, on the other hand, have a much higher conductivity with small size/capacitance in comparison to silicon FETs, enabling a highly efficient power conversion at high switching frequency (f SW ). However, there are several issues that must be resolved before using GaN in automotive. High f SW incurs larger di/dt and dv/dt transitions which injects high frequency electromagnetic interference (EMI) noise into the input bus. This creates unwanted noise or even a malfunction in a safety-critical system. A bulky input filter can reduce EMI, but it greatly increases size and cost. Several techniques [2-5] are reported to mitigate EMI. Frequency hopping using discrete frequencies is proposed in [2], but cannot spread the frequency evenly to lower the peak noise effectively. Alternatively, a series resistor is typically added at the gate of the GaN FET to slow down the transition [3-4]. However, the switching loss is dramatically increased. To mitigate this, adjustable driving strength is proposed in [5]. Unfortunately, the sensing and driver delays confine its use in low f SW applications, where the switch node rising time is several tens or hundreds of ns. Another issue of high f SW operation is that it causes significant current and voltage spikes due to the parasitics at the drain/source of the high side GaN FET (M H ), which could lead to GaN VDS breakdown or damage on logic-level FETs. Thus, EMI noise suppression and reliable operation of GaN FETs remain as major challenges in realizing high f SW power converters for automotive-use.

Vector control implementation in field programmable gate array for 200 kHz GaN-based motor drive systems

A Digital PWM Controller of MHz Active Clamp Flyback with GaN Devices for AC-DC Adapter.

25.2 A 10mhz 3-to-40v VIN Tri-Slope Gate Driving GaN DC-DC Converter with 40.5dbµv Spurious Noise Compression and 79.3% Ringing Suppression for Automotive Applications

Implementation of FOC algorithm using FPGA for GaN-based three phase induction motor drive

Modified SFB-PI Control in GaN-based High-Speed Motor Drive

A novel active gate drive for HV-IGBTs using feed-forward gate charge control strategy

A Novel Gate Control Strategy for 3.4kv Cascade Sic Mosfets Stack

Vector control IC for permanent magnet synchronous motor

New space vector PWM drive for the control of two-phase BLDC

Application of FPGA in High-Power Multiphase Variable Speed Drives

Frequency Adaptive Resonant Controller Based Current Control of SVG

Vector Control System of PMSM Based on DSP

Variable Frequency Driver System of Asynchronous Motor Based on FPGA

Design of Complex Vector Controller for High-power Induction Machine Drive

Study and Implementation of 600-V High-Voltage Gate Driver IC With the Common-Mode Dual-Interlock Technique for GaN Devices

Monolithic GaN-Based Driver and GaN Switch With Diode-Emulated GaN Technique for 50-MHz Operation and Sub-0.2-ns Deadtime Control

Design and Research of High Frequency Aircraft Motor Drive System Based on GaN-HEMT Paralleling

Speed sensorless vector control induction motor drives fed by cascaded neutral point clamped inverter

Comparative Evaluation of Three-Phase Three-Level Flying Capacitor and Stacked Polyphase Bridge GaN Inverter Systems for Integrated Motor Drives

High performance vector control of IPMSM drive fed by indirect matrix converter

High-Efficient Multi-Vector Model Predictive Control with Common-Mode Voltage Suppression