Abstract:The entire process of atomization of the fuel in an internal combustion engine plays a very important role in determining the overall efficiency of these engines. A good atomization process could help the fuel to mix with the air properly leading to its efficient combustion, thereby reducing the emitted pollutants as well. The recent trend followed by the engineers focused on designing fuel injectors for more efficient atomization is to increase the atomization pressure while decreasing the nozzle orifice diameter. A consequence of this is the development of cavitation (formation of vapor cavities or bubbles in the liquid) inside the injector close to the nozzle. The main reason behind this is the sudden changes in the pressure inside the injector and these cavities or bubbles are usually formed where the pressure is relatively low.This work mainly focuses on studying the formation of cavitation and its effect on the velocity of the spray in the near nozzle region using asymmetrical transparent nozzle equipped with a needle lift sensor with nozzle diameter of 0.35 mm at 300 bar of injection pressure. The experiment consists in recording of several image-pairs, which are separated by about 300 ns, capturing the dynamics of the spray, a few millimeters from the nozzle in the direction of the flow. These image-pairs are then used to compute the velocity from the displacement of the liquid structures and ligaments by correlating the first image with the second. About 200 of such velocity graphs are then averaged to obtain a velocity map and is compared with the similar average velocity maps obtained at different times from the start of the injection. The angular spread of the spray from each of these images is calculated as well. The images showing cavitation inside the injector are also recorded at these same instants of time so as to understand the effects of cavitation on the velocity and angular spread of the spray close to the nozzle.

Evaluation of Cavitation Erosion Intensity in a Microscale Nozzle Using Eulerian–Lagrangian Bubble Dynamic Simulation

Numerical assessment of cavitation-induced erosion using a multi-scale Euler–Lagrange method

Numerical Modelling of Bubbling Flow Dynamic Behaviour in a Bubble Column

Simultaneous high-speed internal and external flow measurements for a high-pressure diesel nozzle

Numerical Simulation of the Micro-Jet Velocity and Cavitation-Erosion on an Axisymmetric Nozzle

Evaluation of the physical forces exerted on a spherical bubble inside the nozzle in a cavitating flow with an Eulerian/Lagrangian approach

Evaluation of a new cavitation erosion metric based on fluid-solid energy transfer in channel flow simulations

Numerical Investigation of Microbubble Drag Reduction on an Axisymmetric Body Based on Eulerian Multiphase Model

Numerical Simulation of Cavitation Erosion on A Naca0015 Hydrofoil Based on Bubble Collapse Strength

Exploration of cavitation-induced erosion metrics in throttle flow simulations

Eulerian-Lagrangian investigation of erosion wear within a water-submerged Jet: Two-way coupling

Numerical prediction of erosion due to a cavitating jet

Experimental Analysis of Cavitation Erosion: Parameter Sensitivity and Testing Protocols

Numerical evaluation of the bubble dynamic influence on the characteristics of multiscale cavitating flow in the bluff body wake

Numerical simulation of cavitating flow in liquid Nitrogen through a convergent nozzle

Cavitation in oscillatory porous squeeze film: a numerical approach

Numerical Simulation of the Cavitation Micro–jet Velocity and Erosion on a Plane–convex Hydrofoil with Semicylindrical Obstacle

Numerical Investigation on Transient Internal Cavitating Flow and Spray Characteristics in a Single-Hole Diesel Injector Nozzle: A 3D Method for Cavitation-Induced Primary Break-Up

An Improved Eulerian-Lagrangian Method Combined with Ductile Material Model for Cavitation Erosion Assessment

Effect of cavitation on velocity in the near-field of a diesel nozzle

Investigation of the Enhanced Cavitation Model Considering Turbulence Effects of Fuel Flow in the Injector Nozzle Holes