Abstract:This work illustrates a numerical methodology for the description of effective flow rate of axial piston pumps and motors. The presented mathematical model is similar to classical lumped parameter approaches that are commonly used to simulate hydraulic units; however, this work uniquely utilises a mathematical formulation for compressible flows based on an original description of fluid density. Assuming the behaviour of typical mineral oil, the model can evaluate fluid density for all possible values of pressure while considering the occurrence of gas cavitation (due to the release of air normally dissolved into liquid) below saturation pressure, and of vapour cavitation (due to liquid change of phase) below vapour pressure. The developed simulation model allows a description of several characteristics of the machine (i.e. instantaneous cylinder pressure and density, delivery and inlet flow rates, etc.) in its whole field of operation taking into account conditions of insufficient flow due to cavitation at the low pressure port. Tests were carried out on a swash plate type axial piston pump for open circuit applications to verify potentials of the developed numerical model. Experiments were conducted to test the pump under typical operating conditions as well as situations critical from the point of view of cavitation (high shaft speed, low values of inlet pressure), thus permitting the comparison between the prediction given by the developed model and experimental results over a wide range of data. Results highlight how fluid density changes can be used to characterize effective flow rate but also to justify, in particular operating conditions, the utilization of the approach for compressible flows. Results show that the developed model uniquely allows the calculation of effective flow rate through the pump at fair and extreme conditions, thus permitting the ability to predict limitations of the machine. Furthermore, the realistic prediction of pressures throughout the machine in these conditions leads the accurate predictions of pressure forces and of flow through the lubricating gaps that may be critical in other models.

Cavitation in oscillatory porous squeeze film: a numerical approach

Numerical simulation of flow and heat transfer in journal bearing lubrication

Effects of both cavitation and non-Newtonian behavior on the performance of oscillatory anisotropic poroelastic squeeze film

Numerical Simulation of Cavitating Flow in Water Hydraulic Axial Piston Pump

Numerical Simulation of Cavitation Control around a Circular Cylinder Using Porous Surface by Volume Penalized Method

Numerical Study of the Hydrodynamics of an External Gear Pump

Numerical Simulation of the Cavitation Micro–jet Velocity and Erosion on a Plane–convex Hydrofoil with Semicylindrical Obstacle

Numerical assessment of cavitation-induced erosion using a multi-scale Euler–Lagrange method

Cavitation Model for Oil Film Bearings

Numerical Modeling of the Flow in the Squeeze Film Dampers with Oil Feed Groove by Computational Fluid Dynamic Analysis

Numerical Study of Flow Behavior in a Cavitation Tunnel Using RANS with Scale-Adaptive Simulation (SAS) Turbulence Model in an OpenFOAM Framework

Numerical Simulation of the Micro-Jet Velocity and Cavitation-Erosion on an Axisymmetric Nozzle

Numerical Simulation of Cavitation Erosion on A Naca0015 Hydrofoil Based on Bubble Collapse Strength

Numerical modeling for gaseous cavitation of oil film and non-equilibrium dissolution effects in thrust bearings

Numerical Simulation of Cavitation-Erosion on a Plane-Convex Hydrofoil Using a Homogeneous Mixture Assumption

Modeling and simulation of the squeeze film effect on the MEMS structures

A new cavitation model based on bubble-bubble interactions

A Numerical Approach for the Evaluation of the Effects of Air Release and Vapour Cavitation on Effective Flow Rate of Axial Piston Machines

Cavitation Mechanism of Oil-Film Bearing and Development of a New Gaseous Cavitation Model Based on Air Solubility

A Numerical Method for Simulation of Attached Cavitation Flows

Modeling and simulation of the cavitation phenomenon in turbopumps