Abstract:The paper presents a three-dimensional numerical model that describes the operation of a gear pump, taking into account turbulence and cavitation. The model proposed is implemented in the ANSYS CFX software package. The algorithm for the simulation of moving boundaries (rotation of gears) is based on the immersed solid method. The formation of cavitation in the flow of a viscous incompressible fluid is simulated using a homogeneous two-phase model. The adequacy of the numerical analog developed was verified: on its basis, the analysis of the stability and convergence of the solution was carried out. A series of numerical experiments corresponding to the experimental design stage of creating a fuel system for a promising gas turbine engine were conducted. The technical characteristics of the pump—flow rate, cavitation localization zones, and the degree of cavitation—were obtained. The results of simulation for various operation modes of the unit under study, with different rotational speeds of the gears, are presented. The calculated flow rates for the single-phase (without cavitation) and two-phase flow model are compared with the data of a theoretical calculation using an engineering technique. The supposed cavitation formation zones and the cavitation level are shown and substantiated. The cavitation flow of a real liquid (aviation kerosene) is considered: depending on the rotational speed of the gear, the localization and relative volume of regions subject to cavitation, its concentration, and its possible effect on the consumption rate of the pump and its wear resistance are studied. The simulation results are presented in the form of functional dependences and patterns of the location of cavitation zones. The numerical model of a gear pump makes it possible to carry out numerical experiments instead of expensive full-scale physical experiments and give recommendations for preventive improvement of the design even before the production of prototype products.

Development And Validation Of A Gaseous Cavitation Model For Hydrodynamic Lubrication

Numerical simulation of flow and heat transfer in journal bearing lubrication

Cavitation Mechanism of Oil-Film Bearing and Development of a New Gaseous Cavitation Model Based on Air Solubility

Application of A Novel Gaseous Cavitation Model for Hydrodynamic Bearings in Both 2d Reynolds and 3d Navier-Stokes Equations

Numerical modeling for gaseous cavitation of oil film and non-equilibrium dissolution effects in thrust bearings

Cavitation Model for Oil Film Bearings

Development and Validation of a Three-Dimensional Computational Fluid Dynamics Analysis for Journal Bearings Considering Cavitation and Conjugate Heat Transfer

Improvement And Analysis For A Gaseous Cavitation Model Applied In A Tilting-Pad Journal Bearing

A New Gaseous Cavitation Model in a Tilting-Pad Journal Bearing.

Direct Observation of Cavitation Phenomenon and Hydrodynamic Lubrication Analysis of Textured Surfaces

Analysis on Design Parameters of Water-Lubricated Journal Bearings under Hydrodynamic Lubrication

Lubrication Analysis of Journal Bearing and Rotor System Using Cfd and Fsi Techniques

Influence of Cavitation Pressure on Performance of Sliding Bearings

Turbulent Lubrication Model for Journal-Axial Coupled Hydrodynamic Bearings Without Grooves

Numerical Study of the Hydrodynamics of an External Gear Pump

Motion Modelling of the Floating Bushing in an External Gear Pump Using Dimensional Analysis

Experimental and Numerical Studies of Cavitation Effects in A Tapered Land Thrust Bearing

Research on the cavitation characteristics and structural optimisation of spiral grooved thrust bearing lubricated by liquid hydrogen

Investigation of the Effect of Cavitation and Journal Whirl on Static and Dynamic Characteristics of Journal Bearing

Validation Of Turbulence Models For The Superlaminar Flows In Journal Bearings

A Stability Analysis for a Journal-thrust Hybrid Floating Ring Bearing with the Cavitations Influence