Oil Cavitation Morphology Analysis of Textured Cylindrical Rotating Friction Pair on Circular-Disk End Faces
Junyu Sun,Liyu Chen,Pengfei Qian,Bing Zhang
DOI: https://doi.org/10.3390/machines10111036
IF: 2.899
2022-11-08
Machines
Abstract:Cavitation is a destructive hydraulic phenomenon; it causes damage to small hydraulic machinery and large water-conservancy projects, and cavitation and cavitation corrosion problems are long-standing problems for hydraulic machinery experts. Micro-textures are often machined onto the end face near the indirect contact point to increase the oil film bearing capacity and reduce the transfer torque in hydraulic machinery, but the pressure disturbance caused by the texture dimple and boundary can induce cavitation. To delay or eliminate cavitation on the textured surface of equipment such as mechanical seals and dynamic bearings, the cavitation effect of a cylindrical texture on a rotating frictional pair was investigated from theoretical, imitational, and experimental perspectives. Low pressure is extremely important for inducing cavitation; once cavitation conditions are met, a full bubble can be formed in about 0.015 s. Cavitation mainly occurs at the outer radius of the rotating end face, i.e., in the high-speed region. There is a mutual mass transfer between gas and liquid phases when cavitation occurs, but the generation of cavitation bubbles is faster than its collapse, thus causing an increasing cavitation region.
engineering, mechanical, electrical & electronic