Abstract:The flow condensation heat transfer coefficient of R134a inside two helical micro-fin tubes with outer diameter of 6.35 mm and helical angles of 18o and 28o respectively were experimentally studied at a high mass flux ranging from 500 to 1100 kg m−2 s−1. The condensation temperatures are 35°C, 40°C and 45°C, and the vapor qualities ranges from 0.95 to 1.00 at the inlet section and from 0.00 to 0.05 at the outlet section. Experimental results show that there are annular and intermittent flow regimes inside the tube under experimental conditions, the ratio of annular flow region to the total heat transfer region is about 70%. The liquid film flow changes from rotational flow to coexistence of rotational and horizontal flows when the vapor quality is 0.475±0.08, 0.486±0.06 and 0.521±0.05, respectively and the corresponding saturation temperature is 35°C, 40°C and 45°C. Based on the experimental data, the heat transfer coefficient increases with increasing mass flux and fin helical angle, and with decreasing saturation temperature and Reynolds number of cooling water. In addition, the heat transfer coefficient of annular flow is greater than that of intermittent flow, in other words, the heat transfer coefficient increases with increasing vapor quality. The heat transfer coefficient obtained at high mass flux was compared with the calculated data of some published correlations used at low mass flux. It was found that most correlations underestimate the experimental heat transfer coefficient inside the micro-fin tube, and these prediction deviation increases with increasing mass flux and fin helical angle. By introducing some dimensionless numbers as well as considering the flow mechanism of liquid film inside the tube, two heat transfer coefficient correlations were proposed based on the experimental data. The ratio of liquid film thickness to fin height was used to characterize whether the liquid film flow is rotational flow or coexistence of rotational and horizontal flows in the proposed correlation, which shows a better prediction accuracy with a mean deviation of less than 7.3%.

Boiling Heat Transfer Coefficients in a Falling Film Helical Coil Heat Exchanger for the NH3–LiNO3 Mixture

Numerical Analysis of Heat Transfer Characteristics of a Falling Film Type Plate-Fin Condenser/Reboiler

Experimental Study of Condensation Heat Transfer of R134a Inside the Micro-Fin Tubes at High Mass Flux

Boiling Heat Transfer and Visualization for R717 in a Horizontal Smooth Mini-tube

Experimental and Simulated Study on Mass and Heat Transfer of Falling Film Evaporator for Ammonia-Containing Wastewater

Convective Heat Transfer Characteristics of LiNO3–NH3 Solution with Low Re in a Chevron Plate Solution Cooler

Heat Transfer Characteristics Of Ammonia During Flow Boiling In A Horizontal Small Diameter Tube

Numerical investigations on flow boiling heat transfer of ammonia water binary solution (NH3/H2O) in a horizontal microchannel

Experimental Study of Ammonia Flow Boiling in a Vertical Tube Bundle: Part 4 – Comparative Analysis

Measurement of Boiling Heat Transfer Coefficient in Liquid Nitrogen Bath by Inverse Heat Conduction Method

Experimental Research on the Vapor Pressures of CaCl2–H2O and MgCl2–H2O As Working Fluids of Absorption Heat Transformers at High Temperature

Flow boiling heat transfer and dryout characteristics of ammonia in a horizontal smooth mini-tube

Experimental study of ammonia flow boiling in a vertical tube bundle: Part 2-Enhanced dimple tube with full length solid round PVC nonconductive rod

An experimental study of annular film flow condensation in a micro-fin tube with high mass flux

Experimental Study of Ammonia Flow Boiling in a Vertical Tube Bundle: Part 1 – Enhanced Dimple Tube

Experimental investigation on flow boiling heat transfer of R290, R600a and their mixtures in a horizontal minichannel

Flow boiling heat transfer characteristics and correlation development of R290/R600a mixtures in an internally threaded tube{fr}Caractéristiques de transfert de chaleur par ébullition en écoulement et développement de corrélations pour les mélanges R290/R600a dans un tube fileté interne

Numerical evaluation of the heat transfer in a shell and corrugated coil tube heat exchanger with three various water‐based nanofluids

An experimental study of falling film evaporation in vertical channels with perforated fins of a plate-fin heat exchanger

Assessment of two-phase heat transfer coefficient and critical heat flux correlations for cryogenic flow boiling in pipe heating experiments

A Modified Correlation for Flow Boiling Heat Transfer in Plate Heat Exchangers