Abstract:The strengthening of timber beams with carbon-fibre-reinforced polymers (CFRP) has been widely used in the last decades to enhance the behaviour of historical or new timber structures, usually for bending. While considerable improvement in capacity and ductility is typically achieved, the increase in stiffness was, in many cases, well short of analytical expectations, which tend to overestimate stiffness. This study addresses the problem by investigating the underlying mechanical behaviour using experimental, analytical, and numerical tools on a sample of Norway spruce (Picea abies) beams reinforced with carbon-fibre fabric. In the experimental program, each beam is tested for bending with and without CFRP reinforcement in order to determine specimen-specific stiffness increase on an individual basis. The reinforcement yielded an increase of 27% in capacity, 53% in ultimate displacement, and 133% in compliance, verifying its efficiency. Axial compression tests on an independent sample are also performed to verify modulus of elasticity in compression. Numerical computations based on a beam model and a three-dimensional finite element model are performed with the introduction of separate moduli of elasticity for tension and compression in timber. Inverse computation using the experimental load–deflection curves yielded the moduli and the compression yield stress of timber to provide the best match between tests and simulations. The mean difference of only 6% in stiffness between FEM and the tests is obtained. The dominance of normal stresses in the longitudinal direction is found, in correspondence with the experimentally observed tensile failure of timber (apart from a few defected specimens). Compression yield stresses are within 7% (beam model) and 2% (FEM) error compared with the control axial tests. The differences between FE simulations and tests in ultimate load and compliance are within 1%. This study concludes that the application of CFRP in the composite beams enables the determination of timber material properties opposed to pure timber beams without reinforcement, and the adoption of separate moduli of elasticity for tension and compression leads to adequate modelling of reinforced timber beams.

Stress failure interface of cellulosic composite beam for more reliable industrial design

Micro Failure Analysis of Fiber Metal Laminates

Experimental and Numerical Study on Failure Behaviors of Composite Grid Stiffeners under Tensile and Flexural Loading

Fatigue Performance of Prefabricated Composite T‐beams under Cyclic Overloading: an Experimental Study

Studies on Numerical Buckling Analysis of Cellulose Microfibrils Reinforced Polymer Composites

Exploring flexural behavior of additively manufactured sandwich beams with bioinspired functionally graded cores

Interface stress distribution in FRP-strengthened concrete beams

Fatigue performance of foam-filled sandwich composite beams with web enhanced

Experimental and Numerical Analyses on the Buckling Characteristics of Woven Flax/Epoxy Laminated Composite Plate under Axial Compression

A Novel Rectangular-Section Combined Beam of Welded Thin-Walled H-Shape Steel/Camphor Pine Wood: The Bending Performance Study

Flexure-after-impact behaviors of green composite sandwich beams with natural fiber facesheets and balsa cores

Progressive failure simulation of angled composite beams subject to flexural loading

Finite Element Analysis of Al-Carbon Fiber/Epoxy Composite Laminates

Numerical analysis of fiber reinforced composite material for structural component application

Strain compatibility model to optimise CFRP laminate for shear strengthening of RC beam

Virtual Fatigue Life Prediction of Cellulose Microfibrils Reinforced Polymer Composite

Load-bearing capacity and failure mechanism of integrated fluted-core composite sandwich cylinders

Experimental investigation on flexural performance of concrete beams strengthened with SMA-GFRP-ECC smart composite materials

Experimental, Analytical, and Numerical Assessments for the Controversial Elastic Stiffness Enhancement of CFRP-Strengthened Timber Beams

Design improvement of a composite-to-steel butt-joint based on finite element analysis

Interfacial stress analysis of plated beams under symmetric mechanical and thermal loading