Abstract:We have carried out Investigation into aerodynamic and convective heat transfer of the annular channel. Inner or outer surface of annular channel has shape of blunt-nosed cone tapering to outlet end. Truncated cone connects to a cyclone swirling flow generator. Asymmetric and unsteady flow from the swirling generator in the shape of periodic process gives rise to the formation of secondary flows of the type Taylor-Görtler vortices. These vortices occupy the whole space of the annular channel, with the axes, which coincide with the motion direction of the major stream. Contraction of cross-sectional area of channel (in both cases 52%) causes a marked increase in total velocity of flow, primarily due to its axial component and promotes a more intensive vortex generation. Vortex structures have a significant influence on both average heat transfer and surface distribution. At cross-sections of the annular channel we observe similarity of curves describing distribution of total velocity about wall and heat flux density on the surface. The coordinates of maximum and minimum values of velocity and heat flux coincide. At the average cross-section channel of maximum value of heat transfer is greater than minimum of about by a factor of 2.7 times for outer heat transfer surface and about by a factor of 1.7 times for inner heat transfer surface. Taper channel has a much higher influence on heat transfer of the inner surface than the outer surface and manifests itself at lower values of dimensionless axial coordinate. For the investigated taper cone geometry of the annular channel the heat transfer coefficient of inner surface increases at the outlet section and exceeds value in comparison with straight-line section by 91 ... 98%. Heat transfer of the outer cylinder in the same section increases only by 5 ... 11%. The increase in average heat transfer over the surfaces is 36% and 4% respectively.

HEAT TRANSFER IN THE TURBULENT SWIRLING FLOW IN A CHANNEL OF COMPLEX SHAPE

Modeling of Heat Transfer in Composite Bodies Reinforced with Tubes with Swirlers Through Which a Twisted Liquid Heat Carrier Moves in the Turbulent Mode. I. Statement of the Problem

Turbulent gas flows in channels of different cross-sectional shapes with mass flow

Computational and experimental evaluation of heat transfer intensity in channels of complex configuration for gas flow with different levels of turbulence

HEAT TRANSFER ENHANCEMENT DUE TO SWIRL EFFECTS IN OVAL TUBES TWISTED ABOUT THEIR LONGITUDINAL AXIS

The single-phase swirling flow simulation in a heat exchange channel with coolants counterflow at the operation parameters of PWR

Anomalous Heat Transfer Enhancement in Separated Flow over a Zigzag-Shaped Dense Package of Inclined Grooves in a Channel Wall at Different Temperature Boundary Conditions

Investigation into aerodynamic and heat transfer of annular channel with inner and outer surface of the shape truncated cone and swirling fluid flow

Modeling of MHD Turbulent Heat Transfer in Channel Flows Imposed Wall-Normal Magnetic Fields under the Various Prandtl Number Fluids

Numerical Analysis of Mixed Convective Heat Transfer In a Square Channel with Uniform Wall Temperature.

High-Pr Heat Transfer in Viscoelastic Drag-Reducing Turbulent Channel Flow

Modeling of turbulent flows through annuli with smooth and rough walls; drag reduction and heat transfer

Computational and experimental study of swirling ring flow

Direct Numerical Simulation of Coherent Structure in Turbulent Open-Channel Flows with Heat Transfer

Application of the “k–ε” Model to Open Channel Flows in a Magnetic Field

Fluid Flow and Conjugate Heat Transfer in a Channel with Inflow from a Porous Wall

Forced convection of turbulent flow into the wavy parallel channel

COMPUTATIONAL THERMAL ANALYSIS OF TURBULENT FORCED-CONVECTION FLOW IN AN AIR CHANNEL WITH A FLAT RECTANGULAR FIN AND DOWNSTREAM V-SHAPED BAFFLE

Role of Three-Dimensional Swirl in Forced Convection Heat Transfer Enhancement in Wavy-Plate-Fin Channels

Conjugate heat transfer in spatial laminar-turbulent transitional channel flow

THE EFFECT OF CHANNEL HEIGHT ON FLOW BOILING HEAT TRANSFER AND CHF IN FLAT MINICHANNELS WITH LOCAL HEATING