Abstract:A novel micro-electromechanical systems inertial switch based on non-silicon surface micromachining technology has been designed, fabricated and characterized in the present work. Compared with the traditional inertial switch, a compliant cantilever beam as a stationary electrode has been proposed to prolong the contact time, which can realize sufficient elastic deformation during the contact between the electrodes. The dynamic contact process is analyzed theoretically and the corresponding mechanical impact mechanism is also explained. To investigate the contact-enhancing mechanism of the cantilever beam, the switch applied half-sine acceleration with various amplitudes in the sensitive direction is simulated with ANSYS software. The dynamic simulation results confirm the contact-enhancing mechanism described by the theoretical analysis and it is shown that the contact time (i.e., the switch-on time) can be prolonged effectively by utilizing the elastic deformation of the cantilever beam and increased with the applied accelerations. The inertial switch is successfully fabricated by electroplating and sacrificial layer processes technologies. The prototype has been characterized by dropping hammer experiment. The test results indicate that the contact effect is improved significantly and the contact time is ∼80 µs under the 297 g acceleration, and the maximum value is ∼410 µs for the 672 g acceleration amplitude, which is in general accordance with the simulated results. The mechanical contact between the cantilever beam and the proof mass is evaluated following thousands of impacts. The scanning electron micrographs of the contact surfaces indicate that the all-metal switch still keeps a good mechanical property after suffering the hot contact, and the contact resistance is also stable.

A Low-g MEMS Inertial Switch Based on Direct Contact Sensing Method

Micromachined Inertial Switch for Sub‐g Monitoring Using Gravity‐based Threshold Compensation

A laterally-driven micromachined inertial switch with a compliant cantilever beam as the stationary electrode for prolonging contact time

Design, simulation, and testing of a tunable MEMS multi-threshold inertial switch

A Stiffness-Tunable MEMS Accelerometer

Mechanical Design Optimization of A Single-Axis Moems Accelerometer Based on A Grating Interferometry Cavity for Ultrahigh Sensitivity

Design, Simulation, and Fabrication of a New Three-Axis Inertial Switch with a Triangular Movable Electrode Structure

Design and simulation of a 2-axis low g acceleration switch with multi-folded beams

Low-G Triggered Acceleration Switch for Near-Zero Power Wake-Up Application.

Micro-cantilever Shocking-Acceleration Switches with Threshold Adjusting and ‘On’-State Latching Functions

The Design, Simulation and Fabrication of an Omnidirectional Inertial Switch with Rectangular Suspension Spring

Inertial Micro-Switch Capable of Prolonging Contact Time

A Novel Acceleration Switch with Hat-Like Contact Separated from Proof Mass

A Latching Acceleration Switch with Cylindrical Contacts Independent to the Proof-Mass

Low Voltage, High Speed and Small Area In-Plane MEMS Switch

A Self-Powered MEMS Inertial Switch for Potential Zero Power-Consumption Wake-Up Application

An Acceleration Switch with A Robust Latching Mechanism and Cylindrical Contacts

Design and Experimental Validation of A Restoring Force Enhanced Rf Mems Capacitive Switch with Stiction-Recovery Electrodes

Electrostatic Comb-Drive Actuator for Mems Relays/Switches with Double-Tilt Comb Fingers and Tilted Parallelogram Beams

A Latching Acceleration Switch with Multi-Contacts Independent to the Proof-Mass

Design, Fabrication and Characterization of A Latching Acceleration Switch with Multi-Contacts Independent to the Proof-Mass