Abstract:The paper presents the findings of research on the production of wire from 850 and 585 platinum-based alloys intended for use in jewelry chains. The chemical compositions of two novel jewelry alloys of 585 platinum-containing modifying additives of rhodium and ruthenium are proposed and patented. An analysis was carried out to evaluate the existing section rolling and drawing schedules for the three platinum alloys to identify more efficient drafting methods, with a focus on reducing the labor intensity of metal deformation processes and minimizing the force parameters. A computer model of section rolling for the studied jewelry alloys, based on 850 and 585 platinum, was developed to analyze the shape variation and force parameters of the process and to propose a new deformation schedule for the studied alloys with the accepted reduction distribution per pass. The new deformation schedule was characterized by a more uniform reduction distribution per pass than that observed in the existing schedule, allowing the number of rolling passes to be reduced due to their redistribution. In order to determine the rolling force and to model the process, an approximation formula was used to calculate the time resistance, which is dependent on the total degree of compression. By using proprietary software and computer simulation, the parameters of wire drawing with a diameter of up to 0.25 mm from the studied alloys were calculated, which allowed the deformation and force parameters to be assessed when implementing the proposed drafting schedule. In addition, it was established that the drawing process exhibits a sufficiently high safety factor and low power consumption. It is therefore recommended that the process be subjected to industrial testing. The findings of this research can be recommended for improving the technology of wire manufacturing from the 850 and 585 platinum alloys intended for jewelry chains.

Fabrication of 50.0 μm Ultra-Fine Pure Rhodium Wire, Using a Multi-Pass Wire Drawing Process, for Probe Card Pins

Fabrication of 30.0 μm fine rhodium wire from 80.0 μm initial wire using multi-pass wire drawing process

Fabrication of wire drawing machine

The Art of Electrochemical Etching for Preparing Tungsten Probes with Controllable Tip Profile and Characteristic Parameters

Systematic Study of Electropolishing Technique for Improving the Quality and Production Reproducibility of Tungsten STM Probe

Ultra-Fine-Pitch Bonding Based on Photolithography and Electroplating

Development of A 0.014-Inch Magnetic Resonance Imaging Guidewire

Fabrication of Ultra-Fine and Ultra-Long Copper Tube Electrodes by Ultrasonic High-Frequency Percussion

Rapid Fabrication of High-Aspect-Ratio Platinum Microprobes by Electrochemical Discharge Etching

Fabrication of Polymer Composite Fibers Embedding Ultra-Long Micro/Nanowires

A New Method Of Rapidly Fabricating Micro Probe With Tungsten Wire

Study on Ultrafine Wire Bonding and Performance of Radio Frequency Devices

Improvement of technology for the production of jewelry wire from platinum alloys

Fabrication of Pressure Conductive Silicone Rubber Socket Device by Shape-Controlled Nickel Powders Produced by High-Energy Ball Milling

Numerical and Experimental Investigation of Trapezoidal Wire Cold Drawing Through a Series of Shaped Dies

Fabrication of high-aspect-ratio metallic microstructures by microelectroforming using silver-coated polydimethylsiloxane molds with controllable wettability

Fabrication of high-aspect-ratio platinum probes by two-step electrochemical etching

Investigation on Drawing Process of Bi-2223/Ag Wires Using Racetrack-Type Dies: Simulation and Experiments

Concept development for fabricating threaded micro-pin using wire-EDM

Fabrication and Electromagnetic Characterization of Ultrasmall Diameter REBCO Wires

A Simple Approach for Fabrication of Microring Electrodes