Abstract:The issue of improving the production efficiency and competitiveness of high-carbon steel wire, determined by a rational ratio of quality and costs of its production, is an urgent task. The main way to solve it is the development and implementation of an effective technical process, the main elements of which are the technological process and equipment for its realization. Since the middle of the last century, domestic steel wire production has been operating on imported equipment, which significantly hampers the use of modern technological processes. This unfavorable situation has been aggravated at present by the imposition of severe economic sanctions by “unfriendly states”. The way out of this situation in the current production is the improvement of existing and introduction of new methods of wire drawing. According to the original methodology the analysis of the existing at one of the domestic enterprises route of drawing of high-carbon wire rope wire with a diameter of 1.70 mm from wire rod of 5.50 mm with the use of standard single monolithic fibers, twin monolithic fibers, roller fibers, as well as modules including roller and monolithic fibers (combined drawing) was carried out. The obtained results have shown that when using standard fibers, the drawing route should be designed with the minimum possible multiplicity, which will provide on the existing equipment to improve the quality of wire and reduce the cost of its production. The greatest efficiency is provided by the application of combined drawing: twofold reduction of drawing multiplicity, energy saving up to 30%, improvement of wire quality by creating a favorable stress-strain state when deforming the wire first in roller and then in monolithic drawing. In addition, in comparison with the roller fibers, the equipment is simplified and the costs of its purchase and operation are reduced. Recommendations on the directions of increasing the efficiency of production in the conditions of existing production, purchase of new imported and designing of domestic drawing equipment are given

Fabrication of wire drawing machine

Copper Wire Multi-Pass Drawing: Process Modeling and Optimization

Fabrication of 30.0 μm fine rhodium wire from 80.0 μm initial wire using multi-pass wire drawing process

Effect of Process Parameters in Copper-Wire Drawing

Development of Wet Wire Drawing Machine and Pass Schedule With Ultra High Speed for High Carbon Steel Wire

Numerical and Experimental Investigation of Trapezoidal Wire Cold Drawing Through a Series of Shaped Dies

Residual Stress Engineering for Wire Drawing of Austenitic Stainless Steel X5CrNi18-10 by Variation in Die Geometries—Effect of Drawing Speed and Process Temperature

Process window and mechanical properties for thin magnesium- and zinc-wires in dieless wire drawing

Influences of Different Die Bearing Geometries on the Wire-Drawing Process

MASS PRODUCTION OF HFCVD DIAMOND-COATED WIRE-DRAWING DIES WITHOUT FILAMENT THROUGH THE HOLE

Investigation of the Mechanics of Wire Drawing

Process Stability and Reproducibility of the Dieless Drawing Process for AZ31 Magnesium Wires

Fabrication of 50.0 μm Ultra-Fine Pure Rhodium Wire, Using a Multi-Pass Wire Drawing Process, for Probe Card Pins

Models for the Design and Optimization of the Multi-Stage Wiredrawing Process of ZnAl15% Wires for Spray Metallization

Concept development for fabricating threaded micro-pin using wire-EDM

Effect of the techniqie of drawing with shear on the structure and the properties of low-carbon wires

Optimization of wet drawing according to the ratio of breaking stress to draw stress

Experimental Research of the Wire Drawing with Composite Ultrasonic Vibration Imposed by Anti-Pull

Study of the Stress-Strain State of the Process of Drawing Wire from an Alloy of Palladium with Nickel

Analysis of Tool Geometry and Lubrication Conditions Effect on the Forming Load During Wire Drawing Process

Influence of high-carbon wire drawing method on its production efficiency