Abstract:Ferritic stainless steels are candidate interconnect materials for solid oxide fuel cells (SOFC); however, the oxidation resistance of commercial stainless steels within the operating temperature range of 700–800°C is not adequate. A relatively thick, poorly conducting oxide layer forms on the surface of the stainless steel interconnect, decreasing cell performance. One way of modifying the oxidation behaviour of an alloy is through surface treatment. The aim of this work is to perform a systematic study of the effect of surface treatment (sandblasting and cold rolling) on the oxidation behaviour of three different ferritic stainless steels at 800°C in air. Oxidized specimens are characterized using X-ray diffraction (XRD) and scanning electron microscopy (SEM). In addition, specimens oxidized under the same conditions for 15min are examined using secondary ion mass spectrometry (SIMS) depth profiling and X-ray photoelectron spectroscopy (XPS) depth profiling.For all three steels, the as-is (undeformed) specimens have a lower mass gain than the deformed specimens. The steel with the highest Cr content has significantly higher mass gains than the other two steels, which have similar mass gains. X-ray diffraction and electron microscopy results indicate that the oxide scale formed on all the specimens consists of an inner layer of chromia and an outer spinel layer. The relative amounts of the two oxide phases present depends on both the steel and treatment condition. The presence of insulating oxides at the metal/oxide interface is detected with both surface science techniques and electron microscopy.

Method to Measure Area Specific Resistance and Chromium Migration Simultaneously from Solid Oxide Fuel Cell Interconnect Materials

LSM Protective Coatings on Stainless Steel As Interconnects for Solid Oxide Fuel Cells

Metallic Interconnects for Solid Oxide Fuel Cell: Performance of Reactive Element Oxide Coating During 10, 20 and 30 Months Exposure

Metallic interconnects for solid oxide fuel cell: Performance of reactive element oxide coating during long time exposure

Development and Application of HVOF Sprayed Spinel Protective Coating for SOFC Interconnects

Ni–Co/ZrO2 Composite Coatings via Electroless Plating on Crofer 22APU for SOFC Interconnect Applications: Oxidation and Chromium Vaporization Behavior

Metal-Supported Solid Oxide Electrolysis Cells with Coatings to Suppress Chromium Migration

Comparison of iron and copper doped manganese cobalt spinel oxides as protective coatings for solid oxide fuel cell interconnects

Degradation analysis of commercial interconnect materials for solid oxide fuel cells in stacks operated up to 18000 hours

The effect of surface treatment on the oxidation of ferritic stainless steels used for solid oxide fuel cell interconnects

Characterization of La0.8Sr0.2Co0.5Mn0.5O3-δ Coating on Alloy Interconnect in SOFC

Test and Modelling of Solid Oxide Fuel Cell Durability: A Focus on Interconnect Role on Global Degradation

Characterization of Metallic Interconnects Extracted from Solid Oxide Fuel Cell Stacks Operated up to 20,000 h in Real Life Conditions: The Air Side

Mechanical characterization of oxide coating–interconnect interfaces for solid oxide fuel cells

Mechanical reliability and life prediction of coated metallic interconnects within solid oxide fuel cells

Performance of stainless steel interconnects with (Mn,Co)3O4-Based coating for solid oxide electrolysis

Protective coating based on manganese–copper oxide for solid oxide fuel cell interconnects: Plasma spray coating and performance evaluation

An investigation of Cr vaporization from SUS430 metallic interconnect and deposition on (La,Sr)MnO 3 cathode of intermediate temperature solid oxide fuel cells

Effect of Rare Earth Y and Metal X (Co, Mn, Ni, Cu) Elements on Cr Diffusion Behavior of SOFC Metallic Interconnect

Thermal Stress Analysis of Solid Oxide Fuel Cells with Chromium Poisoning Cathodes

Oxidation behavior of metallic interconnect in solid oxide fuel cell stack